Fishing bream from a boat gives anglers opportunities that are not available when angling from shore. You get access to deep pits, brows and river dumps where trophy animals that avoid shallow water during the day feed, using a boat allows you to precisely feed the point and equip directly under the nose of the fish, which greatly improves the effectiveness of fishing.
However, this method requires a special approach to the choice of gear, since the space for maneuver is limited to the sides. Anchorage It becomes a critical process that all fishing depends on, and a boat that gets up wrong can ruin the whole thing, scaring the fish or making it impossible to cut.
In this article, we will analyze all the subtleties of preparation for departure, the choice of optimal places and the technical nuances of fishing on the side fishing rod and bottom tackle. You will learn how to properly prepare bait and what secrets experienced breeches know.
Selection of location and search tactics
The search for a promising place begins long before the tackle is thrown, the bream is a bottom fish and a schooling fish, preferring to stay in areas with a hard clay or shell bottom, and he is not interested in silted waters without a current where he has nothing to breathe.
The ideal place to fish is to get out of a deep pit, called a table or plateau, where the fish feeds by passing along the brow. echoer It will be your best assistant in determining the bottom relief and detecting clusters of fish.
When choosing a point, the direction of wind and current should also be considered. The boat should be installed so that it is higher upstream from the feeding point, and the gear lies along the side, not getting confused under the bottom.
Often, breams come up to steep shores, where the depth begins immediately from the water's edge, and in these places you can catch even without long throws, lowering the gear vertically down, the main thing is to keep quiet, because at depth the fish can hear blows to the hull of the boat.
Boat fitting and anchoring
The right anchoring is the key to successful fishing. For bream fishing, you usually use a two-anchor scheme, one on the nose and one on the stern, which allows you to rigidly lock the craft perpendicular to the current or the wind.
One anchor is only allowed on strong currents when the boat is turning its nose against the water, but with a weak wind or a change in direction, the boat can start to turn, which will confuse the tackle. Fala (anchor ropes) should be of sufficient length so that when the water rises, the boat does not rip off from the point.
⚠️ Warning: Never tie the anchor tile directly to the transom or the side of a PVC boat without the possibility of a quick discharge. In high winds or currents, the boat can flip or drag under water. Use special anchor ropes with float-buoys.
For the quiet installation of anchors, it is better to use an electric anchor winch or gently lower them manually so as not to create splashes. The noise from the fall of a heavy anchor can scare away a cautious bream for a long time.
It is most convenient to be in the boat so that the fishing rods are on the sides, and the fishing cage is in the stern or at the nose, but always outside the throwing zone of the gear, this will prevent the fishing line from getting tangled when catching.
Boat fishing gear
The fishing arsenal for fishing from a boat is very different from the shore one, it does not require long rods for long casting, on the contrary, it is most convenient to use short fishing rods from 1.5 to 2 meters in length.
The main gears are:
- 🎣 The fishing rod A short angler with a nod or float, allowing you to feel every touch of the fish.
- 🎣 Ring-ring - bottom tackle, where the feeder with bait is on a separate cord, and the line with hooks slides along it.
- 🎣 spring - a donut with a feeder-spring fixed at the end of the fishing line, effective on the flow.
The coils are used inertial or simple non-inertial size 2000-3000. The main requirement for the coil is the reliability of the friction, since the bream at depth resists violently. It is better to put a monophilic line with a diameter of 0.25-0.3 mm, as it stretches and helps to extinguish the jerks of the fish.
Nods for side fishing rods should be rigid so that they do not bend the current, but sensitive enough to register a bite. Often use metal or lausan nods 15-20 cm long.
☑️ Checking tackles before exit
Bait and bait
Without proper feeding, fishing from a boat becomes a lottery, and the task of bait is not to feed the fish, but to bring it to the point of catch and keep it there, the basis of the mixture must be heavy, so that it does not immediately blow away the current.
The composition of bait necessarily include:
- 🌾 millet boiled to a state of semi-readiness, it creates a cloud and a nutrient base.
- 🪱 Living component - chopped worm, worm or moth, which cause bream to look for food in the bottom.
- 🍪 Flavors Anise, vanilla, cinnamon or special fishing sprays that attract fish from a long distance.
They use nets or special closed feeders to bring the feed to the bottom, stuffed with bread, porridge or cake, and lowered downstream from the wells, and the current washes out the feed particles, creating a plume that finds the bream.
As bait, the competition is left out of the dung worms or a sandwich of worm and squirrel. Bream likes a bulk nozzle, so the hooks must be large enough (No. 6-8 according to the European classification) with a long forearm.
The secret ingredient of bait
Many experienced anglers add some soil from the same pond where the fish is fished, which reduces the caution of the fish, as the smell and color of the bottom become familiar to them, and adds ground shells, pearls, which create a crunch that attracts bream.
Fishing and catching techniques
The technique of fishing from a boat involves constant control of the tackle, the angler holds the angler in his hand or places it in the holder so that you can see the nod. When pecking, the bream often first "try" the nozzle, which is expressed in light sticks, and then a sharp nod down or to the side.
The cut should be short and sharp, but not too amplitude to not tear the lip of the fish. After the cut, you should immediately feel the weight of the fish and start catching. Bream at the depths can behave in different ways: either violently resist or "give a candle."
You can catch it safely, keep the line from sagging. If the bream goes to the side, it needs to be turned around, lifting the rod upwards. You should raise the fish to the surface quickly so that it does not notice the boat and does not go into the grass or driftwood.
To extract fish from the water, be sure to use a lift. Bream, when you see the light and silhouette of the angler, can make the last jerk and get off. The sucker should always be ready for work, with a long handle and a small net.
To bream is not afraid of the shadow of the boat, try not to make sudden movements over the water and do not shine a flashlight into the water. When fishing at a depth of more than 3 meters, this is less critical, but in shallow water (up to 2 meters), masking is mandatory.
Comparison of fishing gear from a boat
The choice of a particular gear depends on the fishing conditions, the strength of the current and the preferences of the angler. Below is a table that helps to determine the choice of the optimal tool for different situations.
| Parameter | The fishing rod | Ring-ring | Donka with a feeder |
|---|---|---|---|
| Range of fishing | Vertically under the boat | Along the current (5-15 m) | Along the current (3-10 m) |
| Sensitivity | Tall (hand) | Medium (nod) | Low (nod/signaler) |
| Fishing activity | High (constant monitoring) | Medium | Low (passive fishing) |
| Efficiency of baiting | It requires precise feeding. | Maximum (train) | High (local spot) |
The fishing rod requires constant participation of the fisherman, but it gives better contact with the fish. Ring is a classic bream fishing on the current, allowing you to catch a large area of the bottom without constantly throwing gear. The dong with a feeder is good for passive fishing, when you need to leave the tackle alone for a while.
Experienced anglers often combine tackles: one or two fishing rods are held in their hands for active fishing, and a pair of bottoms are left as backups, which allows you to cover different horizons and tactics of finding fish.
The secret to success is not the most expensive gear, but the right place and quality feed. Bream is suitable for smell and sound, so silence and fragrant bait are more important than the brand of the rod.
Night fishing and safety
Night bream fishing from a boat is considered one of the most preying, but requires strict adherence to safety measures. At night, the bream comes closer to the shore and to more shallow depths, becoming less cautious.
It is a requirement to have every fisherman. lifejacketIn the dark, coordination is disrupted, and the risk of falling overboard or tipping over the boat increases, and you also need to have a good flashlight with a battery supply.
⚠️ Attention: When fishing at night, you can't use powerful lights that are directed into the water immediately after you arrive at the point, the light will scare the fish away, you first need to anchor silently, feed yourself, and then, after 30-40 minutes, turn on the faint backlight.
To signal the bite at night, they use fireflies-batteries fixed to a nod, or electronic alarms with sound. The sound signal is especially convenient, since it allows you to distract from the gear without missing the approach of the fish.
Remember mosquito and midge repellents. At night, insects can be a real problem in the water, distracting from fishing and spoiling your mood. Warm clothing is also a must, as it is much colder at night than during the day.
How do you sleep in a boat?
For multi-day fishing, fishermen often sleep in the boat, and for this, an inflatable mattress or cot is laid to the bottom. It is important to check the weather forecast: when the wind is increased or a thunderstorm, sleeping on the boat on the water can be dangerous. It is better to sleep on the shore, tying the boat.
Frequently Asked Questions (FAQ)
Which outboard motor is better for catching bream: electric or gasoline?
For catching bream, preferably motorIt works silently without scaring the fish, and it allows you to maneuver exactly at a point. A gasoline engine is good for quickly moving to the fishing site, but before you start fishing, it is better to turn it off or raise it so that the vibration does not scare away the bream.
Why does the bream not bite, although there is bait?
There are several reasons: change in atmospheric pressure, wind direction (northern wind often worsens the peck), or too much feed when the fish is fed bait and ignores the bait. Try changing the bait or switching to a smaller fraction of the feed.
Do I need to use leashes when fishing from a boat?
The use of leashes from thinner fishing line (0.18-0.2 mm) is justified when fishing on clear water or with sluggish stick. On deaf-silted water bodies with murky water and active stick, you can catch without leashes to reduce the number of cliffs against the shell.
How far from the boat should the feeder lie?
The optimal distance from the boat to the hooks is 3-7 meters. If the feeder is too close, the bream may be frightened by the shadows of the boat and sounds. If too far, it will be inconvenient to catch the fish, and the gear may become entangled under the boat.
Can you catch a bream from an inflatable boat without a motor?
Yes, of course. A rowboat is even preferable for quiet fishing, because it's more stable and doesn't emit vibrations, and the key is to anchor properly and balance properly so you don't flip over when you're catching a large one.