Bottom fishing with a rubber shock absorber, popularly referred to simply as “rubber” remains one of the most effective ways to catch peaceful fish. However, the main obstacle for many novice anglers is the issue of getting gear to the fishing point, especially if there is no boat at hand. Throw the rubber band off the shore far and accurately - this is a skill that requires understanding the physics of cargo flight, proper preparation of equipment and proven equipment.
Many people mistakenly believe that without a boat, gum fishing is only possible in narrow channels or at the very edge of the water. ion And knowing the secrets of loop formation, you can get a loader to a distance of 30-50 meters, and sometimes even further, and in this article we will examine all the nuances that will turn chaotic attempts into confident, long-range throws that allow you to catch promising eyebrows and pits.
The principle of operation of gear and range requirements
The method is to use the elasticity of rubber, which allows the hooks to be pulled to shore after being thrown to bait, and then smoothly return them to their starting point. However, for the gear to work effectively, the rubber shock absorber must be stretched in water. Optimal stretching of the rubber band is 3-5 times its length in a calm state.This requires the initial distance of the boat.
If you plan to catch on a classic tackle with 5-7 hooks, you will need to deliver the cargo to a distance exceeding the length of the working part with hooks and the rubber itself. Length calculation It is made individually: if the working part of the fishing line with hooks is 10 meters, and the rubber stretches 4 times, then you need to throw the load at least 25-30 meters from the shore. Only in this case the hooks will lie at the bottom in the right place.
Using too short a throw will cause the hooks to be pulled on land or in coastal grass when you try to pick fish or replace the nozzle. So the question of how to throw the gum away is key to successful fishing. jet-gum (model LC-1 or LC-2) has the property of losing elasticity when stretched, so the reserve length during throwing should be reasonable.
The main goal of the throw is to overcome the distance equal to the length of the line with hooks plus the length of the unstretched rubber multiplied by the tensile coefficient.
Equipment required for long-range casting
To do a long-range launch without a boat, you don't have enough physical strength. You need specific equipment that minimizes air and water resistance and also protects the process. loadIt should be streamlined, heavy enough (usually 300-500 grams), but not excessive, so as not to break the rubber when jerking.
The second critical element is the coil or the coil. ionization With a good brake, or a wide wooden motif that's comfortable to hold in your hand, and using narrow motovils or plastic bottles often causes the line to overlap and malfunction in flight, which negates all efforts.
- 🎣 gruzillo: lead, drop-shaped or pear-shaped, weighing 300-500 g, preferably with a soldered ring for fastening.
- 🧵 Main line: diameter 0.4-0.6 mm, not less than 50 meters long, wound on a coil or coil.
- 🛡️ Hand protection: tight gloves or finger, as the line when unwinding can severely cut the skin.
Special attention should be paid to the attachment of the cargo to the main line, it is recommended to use a carbine or a reliable knot that will not be untied from a jerk, and experienced anglers advise to carry a spare load, since when casting from shore, especially in overgrown water bodies, losses occur often.
Preparation of gear for throwing: step-by-step instructions
The success of long-range casting depends on 90 percent proper preparation. Chaotically lying on the ground line inevitably gets confused. There is a proven method of laying the line that ensures smooth flight of the cargo. First of all, you need to choose a flat platform on the shore, free from tall grass, bushes and stones.
The preparation process starts with laying out the main line, which you have to pull out of the coil or the coil and put it on the ground, and the best way is to lay it with rings or pucks, and you take a line, you measure it about a meter and a half, you put it on the ground with a ring, then you take the next section and you put it on top of the first one, so the whole line is placed in neat rings on top of each other.
☑️ Preparation for throw
It is important not to confuse the sequence: the load must lie separately, away from the rings of the line, so that when throwing it does not catch on them. The rubber shock absorber at this point must be securely fixed on the shore (for example, tied to a peg or just lie loose if you are sure that it will not be dragged by the wind). Tension control At this stage, the line should lie free.
⚠️ Attention: Never wind the loose end of the line on your arm or leg before throwing! With a sharp jerk of the load, this can lead to serious injuries, up to a fracture or loss of a limb. The line should be freely reeled off the motif or rings on the ground.
Hand-held Shore Throwing Technique
There are several throwing techniques, but for long distance delivery without a boat, the most effective method is the pendulum or sling using an inertial coil. If you use a simple roller, you use a direct throwing technique with your hand. Consider the manual throw option, since it is the most versatile and does not require additional equipment.
Stand sideways to the water, face your intended flight path. Take the truck in your right hand (if you are right-handed), and the coil or a stack of fishing line rings in your left. Make 2-3 swinging movements to set the load to the amplitude. At peak movement, when the load is directed towards the pond at an angle of 45 degrees, make a sharp but smooth swing of your hand, releasing the load.
The key is to let go of the line, and it has to start unwinding at the time the cargo starts flying, and if you let it go early, the cargo will fall within 5 meters, and if you do later, the line may not be able to unwind and pull the load back. Synchronization Hand movements and the release line comes with experience. Try not to make sharp jerks, but work with the whole body, transferring the weight of the body from the back foot to the front.
- 🌊 The angle of the throw.: Try to throw at an angle of 45-50 degrees to the horizon for maximum range.
- 💨 Wind accounting: with side wind aim with adjustment for demolition, with a counter wind - increase the throwing force.
- 🏃 Position: legs on the width of the shoulders, the body is deployed, the eye is directed to the point in the water where the load should fall.
The secret of the long-range cast
You can use firing to extend your range, and you can tie a thin cord (10-15 meters) to the main line, and then you pull the load at the end, and then you pull it up, and with it, you pull up the main line, which flies easier and further.
Using spinning to throw rubber bands
If you don't think it's efficient enough, or if you need a really long distance (over 40 meters), spinning will come to the rescue, which is the most civilized and safe way, but there's a nuance here: not every rod will do the job.
It is required to throw rubber bands spinning-power It's a test of 100 grams or more, and you can just break a regular light stick under the weight of the load and the resistance of the line. Heavy The coil must also be reliable, preferably with a bytranner or easily adjustable friction, so that the line goes freely.
The spinning technique is similar to the classic jig throw. The load is attached to the main line through the vertebral line. The line is pre-arranged with rings on the ground or, if length permits, is reeled off on the spoole of the coil. When casting, it is important to ensure that the line does not get tangled by the rod rings. After the load falls into the water, the line is selected manually or worn out with a coil until the rubber band is stretched.
| Parameter | Hand-drive | Spinning throw | A boat throw (for comparison) |
|---|---|---|---|
| Range. | 15-30 meters | 30-60 meters | Anything. |
| precision | Low. | High. | Maximum |
| Security | Medium (risk of cuts) | High. | High. |
| Complexity | It requires training. | It requires a powerful form. | Demands a boat. |
Using spinning not only increases the range, but also significantly improves the accuracy of hitting the desired point, for example, through a window among the water lilies or on a specific eyebrow. However, remember that the sharp tension of heavy rubber can put a strain on the form when sampling, so be careful.
If you use spinning for throwing, be sure to check the bandwidth for cracks before fishing. Heavy loads when casting put enormous pressure on the ring at the start.
Common Mistakes and How to Avoid Them
Even with the theory, beginners often face problems at the first throw. The most common mistake is to try to throw a tackle without untangling the line. Having even one knot or hook for the grass will cause the load to fly in the wrong direction, and the fishing line will become entangled in a “beard” that will take a long time to disassemble.
Another mistake is choosing the wrong place to throw, and if you have trees, bushes or high reeds behind you, the probability of a swing hit is 100 percent, always provide yourself with a free sector to swing, and it's also dangerous to throw other anglers or vacationers in the direction, which is a violation of the rules of safety on the pond.
⚠️ Attention: Never leave a tight gum unattended and without visible markings (buoys, flags) in the dark or in high water, it can come across a passing boat or bather, which is fraught with serious consequences.
Fishers often underestimate the strength of the current, and the gear that is abandoned can shift downstream, and the rubber band will lie downstream, not across, and along the shore, so that you can avoid this, when you throw it from the shore along the current, aim upstream from the intended fishing point, so that the water drift compensates for the displacement.
FAQ: Frequently asked questions
What weight is optimal for throwing rubber bands from the shore?
The optimal weight for hand-throwing is 300-400 grams. The lighter load (200 g) can fly further, but it will be carried by the current, and it holds the tension of the rubber band worse. The load is heavier than 500 grams with the hand to throw far and precisely extremely difficult without the risk of injury.
Can I throw a rubber band with spinning if the rod test is 40 grams?
It is strongly recommended that a 300+ gram load be thrown with a rod with a test of up to 40 grams will break the form ("whip") in 99% of cases. For gum you need specialized "sticks" with a test of 100-150 grams or throw the load separately from the rod, tying a thin cord to it.
What to do if the cargo is stuck in the snags at the bottom?
Don't pull as hard as you can -- tear a rubber line or a line. Try to relax the tension by cruising closer to the water or by stepping aside, and make a few jerks with different amplitudes. Sometimes it helps to bulk the line with your hands (in gloves), changing the angle of tension. If it doesn't help, you have to swim or use the uncouple if it is designed for the cargo.
How to calculate the length of the rubber band for throwing from the shore?
The length of the gum depends on the desired fishing distance. The formula is simple: Length_rubber = Distance_catch/4 (stretching coefficient). For example, to catch 20 meters from the shore, you will need about 5 meters of gum in an unstretched state. Always take with a margin of 10-15%.