Buy an electric motor Haswing: a guide to selection and operation

Buying an electric outboard motor is not just a change in traction, it is a transition to a fundamentally different level of comfort and environmental friendliness on the water. Haswing It's a very strong entrenchment in the minds of fishermen and boaters as a synonym for affordable reliability. buy an electric motor Haswing, which will last for many years, you will have to understand the line of models, compatibility with your boat and the nuances of the selection of a battery.

Electric traction allows you to forget about the smells of gasoline, vibration and constant maintenance of the engine. Haswing It offers a wide range of solutions, from compact models for inflatable boats to powerful systems with GPS anchors for boats, but choosing a particular model can be confusing for a beginner because of the variety of specifications such as thrust in pounds, system voltage and type of control.

In this article, we will discuss all aspects of owning an electric motor from this manufacturer, we will discuss the technical features, compare popular series and give practical tips on operation to make your decision. buy an electric motor It was the beginning of a new and more enjoyable era in your fishing or cruising.

Advantages of electric traction Haswing over gasoline analogues

The main argument in favor of switching to electric traction is the quietness of the work. Haswing It is famous for its low-noise engines, which are critical for fishing on cautious fish such as pike or perch. The absence of vibrations in the hull of the boat allows you to hear the slightest bursts and bites, which greatly improves the efficiency of fishing.

The second important thing is cost-effectiveness, and the cost of one hour of electricity is ten times lower than gasoline. electric motor Haswing It requires little maintenance: there is no need to change the oil, filters or spark plugs, just periodically check the condition of the screw and clean the shaft from algae.

And environmental friendliness is also important: by releasing exhaust gases into the atmosphere, gasoline engines pollute not only air, but also water. Electric models are completely free of this disadvantage, and they are ideal for use in protected areas where there are strict restrictions on the use of internal combustion engines.

⚠️ Warning: Despite the tightness of the design, you should not completely immerse the motor in water for a long time, especially if you use acid batteries, the vapors of which can be aggressive.

It's important to note the ease of management. Haswing They are equipped with ergonomic rumples with telescopic handles that allow you to adjust the sinking of the screw on the go, which ensures versatility in shallow water and in deep areas of the reservoir.

Overview of popular series: Osapian, Cayman and Proval

Product line Haswing It is quite extensive and to the right buy an electric motorYou need to understand the differences between series, each one is tailored to a different type of task and a different type of boat.

Series Osapian (Models 55, 70, 80, 100) are classics of the genre: these are robust tiller-controlled engines designed for boats from 3 to 5 meters in length, they are simple and have high maintenance, and the thrust varies in these models, allowing you to choose the best option for a light inflatable boat or a heavier aluminum boat.

Series Cayman This is a more advanced level, and these motors are often equipped with a GPS anchor system, which allows you to anchor at the catch point without physically anchoring. Cayman 55 or Cayman 70 It is the choice of those who value comfort and modern technology, who have more powerful batteries (internal or external) and sophisticated control electronics.

Series Proval They're powerful units with thrusts of up to 100 to 120 pounds and up, capable of speeds of up to 10 to 12 km/h on their respective hulls, often with reinforced dead-wheels and large-diameter propellers.

When choosing a series, you should also pay attention to the type of screw. Some models come with two-blade screws for speed, others - three-blade for better traction at low revs. Haswing electric motor It must match the displacement of your boat, otherwise you risk not getting enough speed or, conversely, overloading the engine.

How to calculate the necessary traction and choose a battery

The key to choosing is traction, measured in pounds (lbs). There is a common misconception that traction is directly converted into horsepower, but it is not.

To calculate the required power, the rule is used: 1 pound of thrust for every 25-30 kg of total weight of the boat (hull + engine + battery + crew + equipment). For example, if your kit weighs 600 kg, you will need a motor with a thrust of about 20-24 pounds, but it is better to take with a margin, that is, a model for 30-40 lbs.

The second critical element is the battery. Haswing It runs from 12, 24 or 36 volts. For small thrusts (up to 40 lbs), one 12-volt battery is enough. For high-power models (55 lbs and above), two or three batteries are often required to be connected in series.

• 🔋 AGM/Gel batteries: Ideal for electric motors. They're sealed, maintenance-free, and can withstand a deep discharge better than car starters.
• ⚡ Lithium-iron-phosphate (LiFePO4): They're 3-4 times lighter than lead, have twice the cycle life, and give full power to the last percent charge, although they cost more.
• ⚠️ Starter batteries: They are not recommended for long-term operation, they are designed for short-term engine start-ups and quickly degrade at the deep discharges characteristic of trolling.

The engine's life is directly dependent on the battery capacity measured in Ampere hours (Ah). If the motor consumes 20 Amps and your battery capacity is 100 Ah, theoretically it will last 5 hours. However, in practice, given the losses and the ban on full discharge (especially for lead), the operating time will be about 3-3.5 hours.

⚠️ Warning: Never discharge lead-acid batteries below 50% of their capacity. This leads to sulfation of the plates and irreversible reduction of capacity. LiFePO4 discharges up to 80-90%.

Installation and installation of an electric motor on a boat

Installation process Haswing Usually not difficult, but requires attention to detail. Most models have a universal transom mount, suitable for the thickness of the transom from 30 to 50 mm. Inflatable boats often use special brackets or mount on the nose.

The first step is to securely fix the motor on the transom, and the clamps must be tightened with force to avoid backlash, which can cause the dayville to break or lose the motor. electric motors have a safety pin or cable, which is recommended to be used as additional insurance.

Connecting the electrical part requires the use of cables of the appropriate cross-section. For 12-volt systems and thrust up to 40 lbs, a 6 mm2 (10 AWG) wire is sufficient. For more powerful systems or long wires (more than 2 meters), the cross-section should be increased to 10 mm2 (8 AWG) and higher to avoid voltage drop and heating.

Be sure to install a fuse or circuit breaker in the plus wire as close to the battery as possible, this will protect the wiring from fire in the event of a short circuit, the value of the fuse should correspond to the maximum current consumption of the motor (usually specified in the instructions).

Connection diagram:
[Battery (+)] -- [Fuse] -- -- [Mass switch] -- -- [Motor (+)]
[Battery (-)] --------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Maintenance and care for Haswing

Although electric motors are called "maintenance-free", minimal maintenance is necessary for the long life of the device, the main enemy of the electric motor is corrosion and mechanical damage. After every fishing, especially in salt water, the motor must be washed with fresh water.

Check the odulcs and seals regularly, and if you notice an emulsion (water mixed with oil) in the gearbox, it's a signal that the leakage is not good, so you need to replace the odulcs and oil to avoid jamming the gears.

• 🔧 Lubricant: Once a season, it is recommended to lubricate the moving parts of the lifting and turning mechanism with a special lubricant resistant to washing out with water.
• 🌡️ Storage: In winter, the motor should be stored in a dry room at plus temperature. The battery should be kept on recharging or using a charger with a storage mode.
• 🌀 Screw: Check the screw for chips and cracks. A damaged screw creates vibrations that destroy the engine bearings.

Pay special attention to electrical contacts. Oxidation of terminals can lead to a voltage drop and overheating of connections. Use special sprays to protect contacts (for example, based on lithium or silicone) after cleaning.

What to do if the engine is humming but not spinning?

This is most often a sign of a screw being jammed by a foreign object (flying, algae) or a malfunction of the brush assembly. The first one is to release the screw carefully. The second one requires disassembling and replacing the engine brushes, which is better to trust the service if you do not have experience.

Comparative table of model specifications

To facilitate your choice and help you buy an electric motor HaswingWhich is ideal for you, we have prepared a comparative table of the main specifications of popular models.

Model	Traction (lbs)	Voltage (B)	Weight (kg)	Features
Haswing Osapian 55	55	12	9.5	Classical tiller, telescope. pen.
Haswing Cayman 55	55	12	10.2	GPS anchor, remote control, digital display
Haswing Proval 100	100	24/36	16.0	High power, for heavy boats
Haswing Cayman B 55	55	12	11.5	Built-in battery, full autonomy

As you can see from the table, the weight difference between the models is small, but the functionality can be radically different. Cayman It justifies the overpayment for those who are engaged in professional trolling or like to catch at great depths.

Frequently Asked Questions (FAQ)

Can a Haswing electric motor be used in salt water?

Yes, most models. Haswing They are corrosion-resistant and are made of salt water-resistant materials, but after every fishing trip, the motor must be thoroughly washed with fresh water and smeared with moving parts to prevent corrosion.

What is the real speed of an electric boat?

Speed depends on a variety of factors: the weight of the boat, the shape of the hull, the condition of the propeller and the capacity of the battery. On average, a 55 lbs electric motor on a lightweight inflatable boat with one person develops a speed of 5-7 km / h. On heavier aluminum boats, the speed can be lower, about 4-5 km / h.

Do I need to register an electric motor in GIMS?

According to the current legislation of the Russian Federation, small craft with an engine of more than 8 kW (about 10 hp) are subject to registration. Haswing Normally not exceeding 1-2 kW, they do not require registration and the availability of rights to drive, if the total mass of the boat in running order does not exceed 200 kg.

How long does the battery charge for the electric motor?

Charging time depends on the battery capacity and the power of the charger. A standard charger (usually 5-10 Amps) will charge a 100-amp battery in 10-15 hours. Using more powerful "smart" charges can reduce this time to 5-8 hours.

Finally, the decision buy an electric motor Haswing The brand has established itself as a manufacturer offering a great balance of value and quality, whether it is a simple Osapian model for weekend fishing or a high-tech Cayman for serious trolling, you will find a solution that fully meets your water needs.