PVC boat LX 3400 NDNDT It has long been one of the most talked about models among fishermen and hunters, and its popularity is due not only to its affordable price, but also to its balanced specifications: a roomy body, reliable material and the ability to install the engine to the top of the range. 20 hp However, before buying it is important to know what real owners think about it - what problems they faced, what advantages were revealed in the operation process, and whether it is worth overpaying for more expensive analogues.

In this article, we have collected and analyzed the feedback of the owners. LX 3400 NDNDT In the past two years, we have compared it to competitors (for example, the Frigate 340 or Flying wing 340), and also prepared practical recommendations on the selection of equipment and care. typical "diseases" From adhesive seams to wave control, if you're planning to buy or you're already a lucky owner of this boat, you'll find answers to some of the key questions.

Technical specifications LX 3400 NDNDTWhat you need to know before buying

Model LX 3400 NDNDT class Low-pressure PVC boats (LDPB)So that means that the bottom is not hard, but it's not completely soft, and it's supported by pumped cylinders, which gives you extra stability.

  • πŸ“ Length/width: 340 Γ— 165 cm is optimal for 2-3 people with a load.
  • πŸ‹οΈ Load capacity: up to 500 kg (according to the passport), but owners recommend not exceeding 400 kg for comfortable use.
  • πŸ›₯️ Motor: up to 20 hp (really set 15-18 hp for better handling).
  • 🧡 Material: PVC 1100 g / m2 (according to the manufacturer), but in reviews there are doubts about the accuracy of this parameter.
  • ⚑ Weight: ~45 kg - transportation is possible alone, but better two.

Important nuance: despite the stated thickness of PVC, some owners note that the actual density is closer to the PVC. 900–1000 g/m2This is not critical for calm water bodies, but when actively operating on rivers with stones or frequent stranding, you should consider the risk of damage. Luxury. It's a reinforced bottom that extends the service life.

πŸ’‘

If you plan to use a boat on mountain rivers or in conditions of heavy chop, pay attention to the models of the boat. PVC 1200+g/m2 or a hard bottom (e.g., LX 3400 SDND).

Parameter LX 3400 NDNDT Frigate 340 Flying wing 340
Length Γ— width (cm) 340 Γ— 165 340 Γ— 160 340 Γ— 170
Max engine power (hp) 20 15 20
Weight (kg) 45 42 48
Price (from, rub.) 120 000 115 000 130 000

Pluses LX 3400 NDNDT: what the owners praise

Analysis of reviews shows that the main advantages of the model are associated with its universality and price/qualityHere are the key advantages that users note:

  • πŸ’° Optimum price: One of the most affordable boats in its class with the ability to install an engine up to 20 hp (competitors are often limited to 15 hp).
  • 🚀 Resilience on water: Due to the width of 165 cm and NDND-bottom boat is well kept on the wave (up to 0.5 m) and does not "scour" when moving.
  • πŸ”§ Easy to repair: PVC material is easily repaired with a remplekt, and patches are kept for years when properly pasted.
  • 🎣 Fishing convenience: spacious banks, the possibility of installing seats and sonar, as well as the availability of leer for insurance.
  • πŸš— Easy transportation: folded fits in the trunk of most sedans (package size ~120Γ—60Γ—40 cm).

The boat is often praised for its driving performance with a 15-18 hp engine - with such power, it easily goes to planing with 2-3 passengers, developing a speed of up to 30-35 km / h. Yamaha 15 FMHS The boat accelerates faster than its counterparts with a hard bottom, due to the lower weight.

Another non-obvious plus. low-noise Unlike boats with aluminum bottoms, LX 3400 NDNDT It does not rattle on the wave, which is important for hunters and fishermen who appreciate silence.

πŸ“Š What engine do you use with the LX 3400?
Up to 10 hp.
10-15 hp.
15-20 hp.
No motor (oar)
Other

Cons and typical problems: what owners are afraid of

Despite the positive reviews, the model has weak spotsThe main claims of the owners are:

  • 🧴 Quality of adhesive joints: In the first batches (2020-2021), there were cases of detachment of seams after 1-2 seasons. In new versions, the problem is less common, but you need to check the seams when buying!
  • 🌑️ Sensitivity to temperature: When heated in the sun, PVC can deform and the bottom "bubbly", it is recommended to keep the boat in the shade or use a protective case.
  • πŸ’¦ Condensation inside cylinders: if you do not dry the boat after use, moisture accumulates inside, which leads to mold and an unpleasant smell.
  • ⚠️ Weak points of transom attachment: When you install the engine > 15 hp, some owners complain about the backlash of the transom.

Critical problem: in reviews of 2023 there are cases of rupture of the bottom when grounded with a 20 hp engine. This is because the NDNDB is not designed to handle high impact loads, so the solution is to avoid shallow water or install a motor up to 15 hp.

⚠️ Attention! When buying, check the date of production of the boat. Models Released until 2022, more often have defects seams. The best option is boats 2023-2026 with reinforced bottom in the configuration. Luxury..

Another nuance. completenessThe basic version often lacks useful little things: pump, remix, bag for transportation. You have to buy separately, which increases the total cost.

How to check the quality of the stitches when buying?

1. Visually inspect all joints - they should be smooth, without bubbles and glue leaks.

2. Push your finger on the seam: if it "plays" or leaves, it is marriage.

3. Check the bottom for the presence of folds - they may indicate poor-quality gluing.

4. ask the seller to pump the boat and leave for 10-15 minutes: if the cylinders do not flatten, the leakage is fine.

Comparison with competitors: LX 3400 NDNDT vs Frigate 340 vs Flying wing 340

To see if it is worth paying for timenCompare it to two of the biggest competitors in the same price range.

LX 3400 NDNDT vs Frigate 340:

  • βœ… timen wins by maximum engine power (20 hp vs. 15 hp frigate).
  • βœ… Wide (165 cm vs 160 cm), which improves stability.
  • ❌ frigate lighter by 3 kg and cheaper by 5-10 thousand rubles, but has a thinner PVC (900 g / m2).

LX 3400 NDNDT vs Flying wing 340:

  • βœ… Finger wider (170 cm) and has a stronger bottom, but costs 10-15 thousand rubles more.
  • βœ… U timen better complete set in the basic version (for example, there is a leer).
  • ❌ Finger It is more difficult, which complicates transportation.

Conclusion: LX 3400 NDNDT β€” middle-of-the-road For those looking for a balance of price, power and sustainability, if you want a margin of safety, you better look away. Wingers Or hard-bottom models. If you have a budget, Frigate 340 It's a good alternative.

πŸ’‘

For fishing on calm waters (lakes, ponds) LX 3400 NDNDT For rivers with a current or a sea, it is better to consider models with a hard bottom or PVC 1200+ g/m2.

Reviews of owners: real experience of operation

We have analyzed over 150 reviews on forums (e.g., Fish-House.ru, Lodka-PVH.ru) and in VKontakte groups, the key findings being:

Positive feedback:

  • 🎯 "Bought in 2022, two seasons no problem. Motor Mercury 15 The plane is perfectly pulled, the plane is out with two passengers without any problems. The bottom does not sag, the seams are solid.
  • 🎯 "For its price, it's a bomb! It folds easily, fits in the trunk. Lada VestaFishing is stable, even when you catch up. -Alexei, Yekaterinburg
  • 🎯 "I took the deep-bottomed version of the Suite, I walked through the rocks in the Urals, no punctures, I repaired only small scratches.(Dmitri, Perm).

Negative reviews:

  • 🚨 "After the winter, the stitches bubbled, had to reglue themselves, and the service said that this is a typical problem for the parties of 2021.(Sergei, Novosibirsk).
  • 🚨 "With a 20 hp engine, the translucent luftite had to be reinforced with metal plates. At 30 km / h, the boat begins to wag.(Oleg, Krasnoyarsk).
  • 🚨 "PVC is thinner than stated. I hit the bottom of a snag, I had to patch it. Next time I'll take a model with a hard bottom.β€œ (Anton, St. Petersburg).

Fun fact: owners who keep an eye on the boat (wash, dry, store in a case) rarely complain of serious problems. misuse Or buying fakes.

After each trip, wash the boat with fresh water |Dry the cylinders and bottom before folding | Store in the shade or under the cover | Check the pressure in the cylinders before going out on the water |Treat the seams with silicone lubrication 1 time per season->

Tips for choosing a complete set and tuning

When you buy LX 3400 NDNDT It's worth paying attention to. completeness And what you can do is you can do this with the best of our experience.

Which version should I choose?

  • πŸ›’ Basic: It's good for the rare fishing trips, minus no hard bottom and no leer.
  • πŸ›’ Lux: The best option for regular use, including a reinforced bottom, leer, a bag for transportation.
  • πŸ›’ Turbo: We've added an inflatable keel and reinforced cylinders, which is optimal for 18 to 20 hp engines.

Useful improvements:

  • πŸ”§ Transnant magnification: If you plan the engine > 15 hp, install additional metal plates.
  • πŸ”§ Inflatable keel: Improves controllability on the wave (you can buy separately).
  • πŸ”§ Echo sonar anchorages: Many owners install homemade holders from PVC pipes.
  • πŸ”§ Bottom protective linings: If you run aground often, stick an extra layer of PVC on problem areas.

It is also worth paying attention to accessories:

  • 🎣 Anchor: For a boat weighing 45 kg, an anchor of 3-4 kg is sufficient.
  • 🚣 Oars: in the basic configuration are short oars - it is better to buy collapsible length 180-200 cm.
  • πŸ”‹ Pump: The hand pump is slow, and the electric pump with the gauge will save time.
⚠️ Attention! When installing a 20 hp motor, be sure to check the mounting of the transom. In some batches, the bolts are not strong enough - replace them with stainless M8.

Where to buy and how not to run into a fake

Boats timen are sold in official stores, on marketplaces (Wildberries, Ozon) and at private dealers, to avoid counterfeiting, follow the rules:

  • πŸ›‘οΈ Check the certificate: Official dealers must have a certificate of conformity for the model.
  • πŸ›‘οΈ Look at the package: The original boat is in a strong case with a logo timen And the instruction in Russian.
  • πŸ›‘οΈ Price: If the price is below 110 000 rubles. - this is a reason to be wary (possible fake or used model).
  • πŸ›‘οΈ Feedback from the seller: Check the store rating and real photos from buyers.

Official dealers timen You can check the list of authorized partners on the manufacturer's website. warranty - official sellers it is 1-2 years (depending on the configuration).

If you buy from hand, you must:

  • Check the boat’s passport and production date.
  • Examine the seams and bottom for repairs (patches should be neat, without bubbles).
  • Ask the seller to pump up the boat and leave for 30 minutes - if the cylinders don't deflate, the leakage is fine.
πŸ’‘

The best time to buy is the end of the season (September-October), when many stores make discounts of up to 15-20% on PVC boats.

FAQ: Answers to Frequent Questions about LX 3400 NDNDT

❓ How many people can the boat hold?

According to the passport - up to 4 people, but comfortably - 2-3. When fully loaded (4 people + cargo), the boat sits low in the water, which complicates the management.

❓ Which motor is better to put: 15 or 20 hp?

For most tasks, 15 hp is enough (for example, Yamaha 15 FMHS or Mercury 15The 20 hp engine is justified if you need a power reserve to plane at full load or to overcome a strong current. However, note that from 20 hp, the load on the transom and bottom increases.

❓ How often do I need to pump the cylinders?

Under normal conditions (without punctures) - once every 1-2 weeks. If the boat is stored in the sun, the pressure may fall more often due to temperature changes. Optimal pressure: 0.2-0.25 bar in cylinders, 0.3-0.35 bar in keel (if any).

❓ Can I use a boat in the winter?

Technically, yes, but with reservations: PVC becomes brittle in the cold, and the seams can crack.

  • Avoid extreme temperature changes (do not leave a pumped boat in the cold).
  • After use, dry and store in a warm room.
  • Don’t use the engine on ice, just the paddles.
❓ What remake to buy?

The basic set is a standard remake, but for serious repairs it is better to buy:

  • PVC patches (preferably the same color as the boat).
  • Clay. PVC 900 or Bostik 2402.
  • Solvent for degreasing (e.g., Solvent 646).
  • A roller for rolling seams.

Temporary repairs in the field are suitable flat-cloth (for example, Liquid PVC).