Boat Fishing opens up to the spinner colossal opportunities that are inaccessible with coastal catching. Boat fishing It allows you to reach the most promising points, control wiring and effectively catch deep-sea sections of rivers and reservoirs, and it is here, at depths over four meters, that most often stand trophy perch, large pikes and heavy perch.
Unlike the shore, where the angler is limited by the range and the bottom relief, the boat gives you freedom of maneuver. You can stand directly above the pit or walk along a steep dump, holding the bait in the working area for as long as possible. However, such fishing requires more serious training of gear and knowledge of the technical aspects of the control of the boat.
Success in hunting for a predator depends not only on the availability of fish, but also on the proper supply of silicone. Electric motor Or a well-positioned anchor allows you to make accurate casts and perform perfect step wiring even in high winds or currents. In this article, we will discuss the key points that will turn your fishing into an effective process.
Advantages of boat fishing and position choice
The main trump card of the fisherman on the water is the ability to choose a position. On the shore, you often have to put up with bush thickets, high shore or lack of depth at the water's edge. balk The predator at the foot of the dump almost always attacks the bait that comes down to it.
Distance control is another important factor: In deep water, where fishing is common, 60-70 meters is a working distance, you can't get to those points from shore, and you can get close to them from the boat, and this allows you to use lighter loads, which makes the bait game more natural and attractive for passive fish.
But there are also challenges, because wind and current can quickly deflate the craft, disrupting the wiring rhythm. anchor-tandem or electric motor And you have to stand up to the wind or the current, and you have to stand up to the wind and the current, and you have to keep the boat stable and the throwing is comfortable.
⚠️ Attention: When fishing in windy weather, never get a boat across the wave or current. This creates a huge sailing, the boat begins to uncontrollably unfold, which can lead to water flooding through the side or entangle the anchor shaft in the engine propeller.
Finding fish from a boat is impossible without modern equipment. echoer It's becoming the primary tool for navigation, and it's not only the depth, but also the structure of the bottom, the presence of driftwood, the presence of rocks, and of course the fish itself, and without visualization, the topography of the fishing becomes a chaotic poking bait at random.
Gigg fishing boat fittings
Comfortable fishing has a direct impact on concentration and results. Basic equipment should include a reliable anchor system. For jigs, where accuracy is important, one anchor is often not enough. It is optimal to use a scheme with two anchors: one on the nose, one on the stern, or use an anchor falter with a quick-removal carbine to quickly change position.
The second critical element is a GPS sonar, which allows you to remember the catch points and return to them the next time you visit the reservoir. Deep-sea models Sound sounder sensors are a must if you plan to catch at depths greater than 10-15 meters, where conventional emitters may lose signal.
For fixing boats on a strong current or wind are excellent parachute or cat anchorThe good thing about parachute anchors is that they don't cling to the snags and they're easier to pull out if they do. Metal cats are more secure on a rocky bottom, but the risk of losing gear is higher. The choice depends on the nature of the bottom of the particular pond.
Safety is also important. The life jacket should always be worn, even if you are a great swimmer; cold water and heavy clothing in case of falling overboard can play a cruel joke; also, the boat should have a scoop for pumping water and a spare anchor in case of a major cliff.
Equipment: spinning, coil and line
The jig kit for boat fishing is different from the onshore one. You don't need ultra-long throws, so the length of the rod can be smaller. The optimal range is from 2.10 to 2.40 meters. Shorter spinnings (see below).2.10m) is more convenient for catching large fish, as they are easier to manage in the limited space of the cockpit.
The spinning test is tailored to the conditions. For medium depths and currents, the universal range would be 10-40 grams. If you fish in deep wells with strong currents, you'll need a more powerful form with a test of up to 60-80 grams. Fast or Extra FastTo clearly feel the touch of the bottom and control the cut at great depth.
Why is a wicker better than a monoleaf for jig?
Monophile fishing line has the ability to stretch, which at great depths (more than 5 meters) makes the bite almost imperceptible. The wicker cord has no stretchability, transferring every touch of a fish or bottom directly into the hand of the angler, which is critical for timely cutting of the pike with its hard mouth.
The coil must be reliable and have good traction, the size of 3000-4000 according to the Shimano classification is the middle of the line, and the gear ratio is better to choose the power ratio (about 5.0:1), so that you can confidently pump the fish from the depths and quickly choose the slack of the cord in the wind. Friction It should work smoothly, without jerks, since when fishing from a boat, catching often occurs in a vertical plane.
The main line is only a wicker cord, the diameter is the minimum possible to reduce sailing, but with a margin of safety. For most conditions, the cord #1.2-#1.6 according to the Japanese classification (PE) will work. fluorocarbon It is needed when catching pike, as it easily bites the wicker with its sharp teeth.
Jig Heads and Types of Boat Wires
The most effective boat is the classic stepwireThe idea is simple: after the bait is thrown, the bait falls to the bottom, then there is a 2-3 turn of the coil and then a pause again. The key point is the time of the fall. For active fish it is 2-3 seconds, for passive fish it is up to 5 seconds. If there is no bite, the fall time is increased, reducing the weight of the load.
The cargo varieties affect the game. The classic jig head with a hook soldered into a loader flies further and catches fish better, but has less free play. The offset hooked load gives the bait more freedom, which is important when catching a passive predator. Tungsten cargoes at the same weight have a smaller volume, which improves flight and sensitivity, but they fall to the bottom more loudly, which sometimes scares off fish.
☑️ jig tackle assembly
There are several types of wiring that are worth trying out:
- 🎣 Classic step: 2–3 turns, pause until the bottom is touched.
- 🎣 Aggressive wiring: sharp swing of the rod up with simultaneous winding, used to provoke active fish.
- 🎣 Drawing: The bait slowly drags along the bottom with short, effectively over cold water.
It's important to feel the relief. If you're not feeling the bottom, you've run aground or you've gone to a plateau. You need to adjust your position. The ideal wiring occurs along the eyebrow: the throw is made across the dump, and the winding is conducted parallel to it, so that the bait is constantly on the verge of depths.
Tactics of searching for a predator on a pond
So, looking for fish is not a chaotic journey, but a systematic survey of promising places, and you start by looking at the terrain with a sonar, and if you find a dip, a drifter, or an exit to a plateau, you get up the boat and start the fan catch.
The first one is short, right under the boat, to test the fish's response to the noise of the boat and the presence of people, often a large perch or pike is right under the boat, then the distance is increased, if there are no bites at the first point for 10-15 casts, you should change the place. Jig fishing It's a search for an active predator.
| Type of relief | Possible fish | Tactics of catching |
|---|---|---|
| Cool dump (brow) | Sudak, perch. | Wiring along the brow, step |
| The deep snag | Pike, pike. | Throwing in "windows", use of offsets |
| Smooth plateau (table) | Bersh, bass. | Driving, slow wiring |
| The flip-flopping pit | Big punk. | Pit exit traps, heavy loads |
When you catch a fish, you should remember the spot on the navigator, and if you catch one "fang," there's a high probability that there's a flock nearby, and then it makes sense to anchor and carefully snag the site with various baits. The color change of silicone The size of the bait often helps to stir up the collected fish.
Frequent errors and safety practices
One of the most common mistakes is ignoring the weather: Going out on large water in a light inflatable boat with winds of more than 10 m / s can be dangerous. The wave quickly tires, knocks the boat off anchor and makes fishing impossible. Always evaluate your strength and capabilities of the boat.
The second mistake is using blunt hooks, and after a few fishing or hooks on the rocks, the stinger becomes blunt. Sharpening hooks A dull hook will not penetrate the hard mouth of a pencil at the depths, and you will be left without a trophy. Always carry a marker or sharpener with you.
⚠️ Attention: Never wind an anchor tile on your arm or leg when working with an anchor on the current. A sharp jerk of a boat or anchor hook can lead to serious injury or drowning.
Also, beginners often neglect to adjust the friction, if it is pulled, if a large fish jerks sharply, the cord may break or the gear breaks, if it is too weakened, you will not be able to cut it, Friction must be adjusted to the weight of the intended fish and the strength of the cord before fishing.
Use a yawner and extractor to extract hooks from the mouth of the pike, which will save your fingers from sharp teeth and teeth of the fish, and will allow you to quickly release the fish caught if you practice the principle of Catch & Release.
Keeping up with safety and fishing practices will allow you to enjoy your fishing as much as possible, and remember that nature does not forgive carelessness, but rewards you generously for your knowledge and training. Boat fishing It is a fascinating sport that gives unforgettable emotions from the fight against a strong predator.
The key to success in jig fishing from a boat is the ability to "read" the sonar, correctly place the boat relative to the wind and current, and select the weight of the cargo so that the pause of the bait drop is optimal for the activity of the fish at the moment.
FAQ: Frequently asked questions
What weight jig head to choose for a depth of 10 meters?
For a depth of 10 meters and the absence of a strong current, a load of 20-28 grams is usually used. However, the exact weight depends on the strength of the current, the sailing of the bait and the desired rate of fall.
Do you need a Kevlar leash to catch a pike?
Sudak has no teeth to bite the wicker, so a fluorocarbon leash or twist of the same wicker is enough to target the pike, Kevlar or metal is only needed if pike is common in bycatch.
How to properly cut off a perch from a boat?
The cut should be sharp and amplitude, as the fishing goes at great depths, and the cord is stretched (albeit minimally). After a pause and a sensation of a pump or weight, you need to make a powerful swing of the rod up to cut through the predator's hard mouth.
Can you jig on a inflatable boat without a motor?
Yes, you can, but it's less efficient. A rowboat doesn't allow you to change points quickly and anchor against the current, but for small bodies of water or quiet water, it's a very workable option, especially if you use a cat anchor.