Autumn pike ceases to be an active predator that chases the fry throughout the water area, and shifts to deep brows and pits where the water cools more slowly. It is during this period that classical spinning becomes less effective, giving way to the method of spinning. plumbThis method allows you to catch hard-to-reach places, such as buckets and sudden changes in depths, where it is almost impossible to throw from the shore or even from the side of the boat with a conventional spinning.
Fishing in plumb requires a specific approach to the choice of tackle and, critically, to the equipment of the boat. You do not need to make long casts, but you need high accuracy of bait delivery and the ability to read the bottom relief using the help of the seabed. sonarA properly tuned boat with an anchor system and a sonar turns fishing into a highly accurate process of catching trophy fish.
Many anglers underestimate the importance of the boat's position on wind and current, relying only on luck, but it is the control of the boat that allows the predator to see your bait at the right time. The key to success is not the splendor itself, but the ability to hold the boat strictly above the pike parking point, using cat anchors or modern electric winch anchors. In this article, we will analyze all the nuances, from the choice of a rod to the tactics of bypassing promising places.
Selection and preparation of boats for sheer fishing
For effective fishing pike in the plumb is suitable for almost any boat, whether it is reliable. PVC The main condition is stability on the wave and the possibility of comfortable placement of the angler and equipment, the boat must allow fishing standing or sitting in a high chair to have a good view and the ability to perform sharp cuts.
The anchoring system becomes critical. Using one anchor often causes the boat to turn across the wind or current, making wiring impossible. The ideal scheme is to install two anchors, one on the bow and one on the stern, which allows the boat to be rigidly fixed as it heads to the wave or current, ensuring stability.
⚠️ Warning: When anchoring in a trunk, always tie the anchor tack behind the tailing or use a wagon mechanism. Loss of anchor in the driftwood is a common problem that can turn fishing into a long and dangerous process of retrieving the boat.
And you should also keep in mind noise insulation, especially if you're using a metal boat. Pike, especially large, has excellent hearing and can respond to impacts on the side or bottom. spandex Or use specialized coatings to minimize extraneous sounds when moving around the boat.
The foot-controlled electric motors are great for maneuvering between points, and they allow you to quietly approach the perspective bay and adjust your position without the noise of the gasoline engine that scares fish in shallow water.
Equipment sonar and navigation
Modern plumbing is unthinkable without a high-quality sonar. It's your main search tool, which replaces hundreds of empty casts. This technique is best suited to two-beam models or, even better, sonars with technology. Down Imaging or Side ImagingIt allows you to see the structure of the bottom and the fish in detail.
So the sounder is critically tuned, and you have to calibrate the sensitivity to see not only the bottom, but also the individual driftwoods and the thermal layers, and the pike is often just above the bottom or hidden within the edge of the trunk, and if you see only the bottom line, the efficiency of the fishing will drop dramatically.
Using a mapplotter with loaded depth maps makes it much faster to search, so you can pre-route through known pits and brows, keeping the coordinates of the catch points in the device's memory, and this allows you to return to the tested places with a meter accuracy, even in poor visibility or on high water.
| Type of equipment | Appointment | Criticism |
|---|---|---|
| Echo sounder (2D/3D) | Search for fish and relief | High. |
| GPS-navigator | Preservation of points and tracks | Medium |
| Cat anchor | Fixation in the snags | High. |
| Electric motor | Silent maneuvering | Medium |
Use the Track feature on your GPS navigation while you catch your eyebrows, which will allow you to follow the same trajectory next time and check for missed areas or re-catch good spots.
Equipment: rod, coil and line
The choice of gear for sheer flare is different from the spinning classics. You don't need long-range spinning, on the contrary, it is more convenient to work with a short, hard and sensitive rod. The optimal length is from 1.5 to 1.8 meters. This form allows you to confidently feel the bait and make sharp, powerful cutting, which is critical when fishing at depth.
The rod test must match the weight of the baits used. Pikes typically use ferries weighing between 20 and 60 grams, so the test is in the range of 20-80 The rod is the most versatile, and the rod is preferable to fast or superfast, so that it can only play out the nod or the tip of the rod, rather than the entire form.
The coil must be reliable and have a good friction. Size 2500-3000 according to classification Shimano Many anglers prefer multi-coils because they are smaller, more powerful and more comfortable to hold in your hand when you wiring vertically, but a good meat grinder with a good line is also great.
As the main cord, it is better to use a wicker with a diameter of 0.12-0.16 mm. The wicker cord does not stretch, which gives instant information about the bite and allows the pike to penetrate the mouth at any depth. The monophilic fishing line is stretched, and at depths of more than 5 meters, the cut can be simply idle due to cushioning.
☑️ Checking tackle before exit
Arsenal of baits for vertical flare
The range of pike lures is large, but not all are equally effective. The arsenal is based on vertical splashes that have a specific geometry and a shifted center of gravity, and they don't rotate around their axis like oscillators to throw, but they do transient movements, mimicking a wounded fish.
The popular bait lures are the three-faced, hexagon, and various models with soldered hooks. The color of the bait matters: in cloudy weather and at depth, bright, acidic colors and parrots work better, and on a clear day and on clear water, natural silver and gold.
Balancers deserve special attention. Although they are considered winter baits, in the fall large pikes often attack them with great force. Large balancers of 7-12 cm are suitable for sheer fishing from a boat. Their horizontal play when the rod is flung provokes the predator to attack even during periods of low activity.
⚠️ WARNING: When using heavy glosses and balancers, be sure to use a metal leash. Pike teeth cut the fluorocarbon and braid in a fraction of a second, and the loss of expensive bait will be guaranteed.
The smooth, sluggish play of edible rubber on pause is often the decisive factor when the pike is capricious and ignores active iron.
The secret of the bait color
At depths over 6-7 meters, red is no longer visible to the fish eye and looks black. Use this: If the pike ignores red lures at depth, replace them with contrasting white or acidic, which are seen better.
Search tactics and wiring technique
Looking for a pike starts with looking at the bottom of the pike, and if you're going along the edge or across the pit, you're going to be looking at the sounder screen, and you're looking at any anomalies, rocks coming out, single snags, deep dumps, and if you see a fish arc or a parking lot, you want to see the boat.
The technique of wiring for sheer flare is simple, but requires a rhythm. The classic cycle looks like this: a sharp swing of the rod upwards (amplitude 30-50 cm), followed by a pause during which the rod plans, and the return of the rod to its original position. The duration of the pause is selected experimentally: the active pike is provoked by short pauses (2-3 seconds), passive - long (up to 10-15 seconds).
It's important to keep a constant eye on the bait horizon, and if the sonar shows that the pike is in the halves and you're banging on the bottom, there won't be any bites, use the bill (one thousand, two thousand...) or watch the nod to get the bait up to the right level.
If you don't have a bite, don't be afraid to change the type of wiring. Try to do a series of 3-4 quick strokes without pause, then a long pause. Or just sway a sparkle with minimal amplitude, mimicking the tremor of an injured fish. Often, it is the change of pace that makes the pike attack.
The main principle of tactics: if for 10-15 minutes of active catching of a promising point (snag, dump) there are no bites, change the place. Pike in the autumn is local, and you need to look for it, and not wait for it to come to you.
Frequent Mistakes and Secrets of Skill
One of the most common mistakes of beginners is to play too aggressively; sudden, chaotic movements can scare away the pike rather than interest it; movements must be confident, but not convulsive; and often fishermen forget to disguise: the silhouette of a person in a boat in the sky is clearly visible to the fish, so it is better to sit or use a masking net.
Many people ignore the weather. On a sunny, windless day, the pike can be extremely careful. On those days, it's more effective to fish in deep waters or in murky waters where visibility is limited. Conversely, light ripples in the water hide the angler and make the fish more daring.
Keep in mind safety. Fallow fishing often occurs at depths with the flow, and handling heavy boulders in a boat requires care. Getting a hold of a glitter on your clothes or hand when cut can cause serious injury. Always keep your fingers away from the hook sting and use a yawner and extractor to extract hooks.
The secret to being a good observer is to remember what wiring, color and type of glitter worked in a particular weather today. Fishing is a constant collection of statistics. By analyzing your successes and failures, you will eventually develop your own sense of rhythm and understanding of pike behavior.
Which fishing line is better to choose for a beginner: a wicker or fluorocarbon?
For sheer flaming of the pike, a wicker cord is strongly recommended. It does not stretch, which gives 100% realization of bites at depth. Fluorocarbon can only be used as a leash material, but not as a main line, since its stretchability at depths of 5-10 meters will make the cut ineffective.
Why does the pike not take on the flare, although the sonar shows its presence?
There are several reasons: wrong wiring horizon (pike is above or below bait), too fast or slow play, wrong color or size of the lure. Also pike can be passive due to pressure drop. Try changing the bait to a smaller one or switch to edible rubber with passive play.
Should I use a nod when fishing in plumb?
The use of a nod is a matter of taste, but many experienced anglers refuse it, relying on the sensitivity of the rod form and the tactile sensation in the hand. However, for beginners, nods (especially spring or lausan) are useful: it helps to set the right wiring rhythm and clearly see the moment of touching the bottom or pecking.
Can you catch a plumb from an inflatable boat without a sonar?
You can, but the efficiency of this fishing is extremely low. Without a sonar, you catch randomly, without knowing the topography or the availability of fish. In sheer fishing, accuracy is important, and finding fish using the pumpkin method is time-consuming. Soundfinder is not a luxury, but the main working tool for this type of fishing.