The virtual world My Summer Car It is famous for its unprecedented detailing of mechanical processes, where the player will not only assemble a Satsuma car, but also master the water element. boat-engineBecause the procedure here requires a precise sequence of actions resembling working with real two-stroke engines, without a proper understanding of the mechanics of the game, the boat will remain a stationary piece of plastic on the shore of Lake Peräjärvi.
The key is to realize that the engine won't start on its own, even if there's fuel in the tank, and you need to manually simulate the processes that are going on in the carburetor and the ignition system, operating multiple levers at the same time. Starting the engine It is a balance between the supply of air, fuel and spark, which makes the process both complex and exciting for fans of simulators.
In this article, we will take each step of preparation and launch, paying attention to the nuances that are often overlooked. suckerYou can use the throttle and when to pull the starter cord, and understanding these principles will allow you to confidently scour the lake for fishing or just go for a ride with friends.
Preparation of the fuel system and inspection of nodes
The first step before you try to start is to provide the engine with quality fuel. Unlike the car, the outboard motor in the game runs on a mixture of gasoline and oil, so just pouring fuel out of a canister is not enough. You need to find a special oil bottle for two-stroke engines and mix it with gasoline in the right proportions right in the tank or separate container.
After refueling, you must check the condition fuel-filter, which is often clogged with dirt or rust, especially if the boat has been idle for a long time. If the filter looks suspicious or the engine dies immediately after launch, it should be replaced with a new, pre-dumping residues of old fuel. carburetor.
Also worth noting is a spark plug that may have been soaked or wet from failed launch attempts, twist it, wipe it with a dry cloth or brush it, then check the gap and return to place with a tight swirl key. Sparkling It is the foundation of a successful start, and a weak candle will reduce all other efforts to zero.
⚠️ Warning: Never try to start a motor if you smell a strong smell of gasoline around you – this can cause fuel vapor to ignite in a confined garage space or on a pier.
Customization of the carburetor: sucker and throttle
The most critical stage that most players stumble at is to properly adjust the engine controls before the starter snags. sucker (choke), which cuts off the air supply, enriching the mixture for a cold start, in the game interface, it is usually a left lever or button that you need to pull up or press until a characteristic click.
At the same time with the pump you need to open a little. throttleYou don't have to open it completely, you don't have to open it with a gap small enough to grab the engine, and if you open the throttle too hard, it will dilute and the engine won't start, and if you leave it closed, it will choke.
The order of action should be honed to automatism: first activation of the sucker, then a light press on the gas, and only after that - a jerk of the starter. carburetor At this point, it creates the necessary thinning by sucking fuel into the cylinder. An error in timing or sequence will only lead to idle crankshaft scrolls.
If the engine sneezes but doesn’t start, try changing the throttle position slightly during the starter’s thrust – sometimes you need a millimeter larger or smaller.
Starter cord snatch technique
Physics of the start-up process in My Summer Car It's a mechanical jerk that you have to do by holding the interaction key, and it's not enough to just push the button, you have to pull the starter cord in a sharp motion, mimicking the actual hand force, and if you pull too slowly, the engine won't reach the right speed to ignite the mixture.
It's important to note that after every failed jerk, you should take a little pause to let the fuel in the glass crankcase evaporate. spark-plate And then you have to twist the candle and dry it, and you lose precious game time.
Sometimes it takes a few tries, especially if the engine is cold or the mix settings are not perfect. Listen to the scrolling sound: if the motor makes a characteristic "try" sound, then you are close to success and perhaps you just need to pull the cord a little harder or adjust the suction.
☑️ Engine start algorithm
Problems with sparking and candles
If all the manipulations with the fuel and the starter fail, the problem lies deeper in the system. electricalIn the game, as in reality, the magneto or ignition coil can fail, especially after prolonged operation or water. Check the high voltage wires: they must be tightly worn on the candle and have no visible damage to the insulation.
A common problem is the "drenched" candle mentioned earlier: If you've been spinning a motor with the suction switch on for a long time, gasoline could wash the oil film and soak the electrodes, in which case drying will help: twist the candle, blow the cylinder with several turns of the starter (without the candle), and wipe the part clean.
It is also worth checking the gap of the candle, although in the game this option is often fixed for standard parts. If you have installed customized components, make sure that they are compatible with your own. boat-engineA mismatched candle can produce a faint spark, not enough to ignite a rich mixture.
| A symptom. | Probable cause | Decision |
|---|---|---|
| The engine's not catching. | No spark or little fuel | Check the candle and the sucker. |
| Engine's dead. | Too poor mixture | Add gas or check the filter |
| Black smoke | Excess oil in the mix | Change the proportion of the mixture |
| Strange sound | Bearing problems | Engine replacement or repair |
Adjustment of the mixture in the process of operation
Once the engine is started, you can't immediately give full gas, because it can stall due to a sharp change in load. First, let the engine warm up at idle speeds, gradually removing the engine from the engine. suckerIf you remove the suction too soon, the engine will stall; if you hold it too soon, a candle will fill and black smoke will appear.
During the heating process, watch the sound of the work: a smooth hum indicates the correct setting. If the engine begins to "grow" or the speeds float, try to slightly adjust the position of the throttle. Two-stroke engines The quality of the mixture is sensitive and ideal settings may vary depending on the ambient temperature in the game.
For stable operation on water, it is also important that the fuel tank is positioned correctly and the tube does not twist. In the game, the physics of the liquid in the tank is simplified, but an inverted boat or roll can disrupt the fuel supply, which will cause the engine to stop in the middle of the lake.
The Secret to Stable Work
If the engine stalls when the gas is discharged, then the idle speeds are too low - add a little gas before releasing the starter cord.
Typical errors and ways to fix them
One of the most common mistakes is to ignore the need to mix oil with gasoline. Starting the engine with pure gasoline will quickly overheat and jam the piston group. fuel-mixNot the clean fuel from the pump.
Another mistake is trying to start the engine without getting in the boat or getting in the right position. The mechanics of the game require that the character be next to the motor and interact directly with it. Sometimes players have to adjust the position of the camera to see the control levers.
Remember, after a long period of standing in the water on the bottom of the boats, algae can build up, which increases resistance. Although this does not affect the start, it will make it difficult to move and make the engine run at its limit, which can cause it to stop under load. turret and a mud screw.
⚠️ Warning: Do not leave the engine running unattended on the shore – in the game this can lead to unpredictable consequences, including fire or sailing the boat along the stream.
The main secret of success is patience and exact adherence to the sequence: Podsuction -> Gas -> Snap -> Warming up.
Frequently Asked Questions (FAQ)
Why does the engine start and immediately stop?
Chances are you've removed the pump too early or didn't warm up the engine enough, try keeping the pump on a little longer after start until the rpm stabilizes, and then smoothly turn it off.
Do I need to change the oil in the outboard motor?
In My Summer Car Two-stroke engines don't have a separate oil crankcase like four-strokes; the oil burns with the fuel. So you don't have to change it, but you have to keep adding fresh mixture to the tank.
How do I know if the spark plug is faulty?
If you're scrolling with the starter, you don't have any flashes in the cylinder, or if the engine doesn't try to grab the fuel at all, and the fuel is coming in, you probably have a dead candle, and you can replace it with a new one from the inventory.
Can I start a boat without a suction?
In theory, a hot engine doesn't need a suction, but it's almost impossible to start a cold engine in the game without enriching the mixture through the suction, especially in the morning or after a long downtime.
What if the fuel runs out in the middle of the lake?
You will have to paddle to the nearest gas station or shore. in the game there is no way to transfer fuel from the canister to the tank of the boat while on the water, so always monitor the fuel level before going out.