How far to release the Wobler when trolling: schemes and calculations

The effectiveness of trolling depends on how well your artillery battery is built. Many newcomers make the same mistake when they go out to the water: they release the baits randomly, relying on luck or the example of their neighbor. How far to let the Wobler goThe right distance not only affects the game of bait, but also the likelihood of overlapping, as well as the wiring horizon.

The optimal length of the holiday varies widely, from 10 meters in shallow water to 50-70 meters in deep fishing. The choice of a particular figure depends on many factors, including the type of bottom, the speed of the boat and, of course, the specifications of the wobbler itself. In this article, we will discuss in detail the physics of the process, the effect of the type of fishing line and proven bait layouts so that you can maximize the catch.

Factors affecting the choice of vacation distance

The first thing that fishermen should consider is depth Each bait has a passport entrapment, but in reality it is only achieved at a certain length of vacation. If you release the vobler too close to the transom, it will swim above the declared horizon, scaring the fish, not attracting them. For example, to drive a deep sea entrapment 5-6 meters, often requires to release it 40-50 meters.

The second critical parameter is speedThere's a direct relationship: the higher the speed, the stronger the water resistance, and the higher the bait rises. To compensate for the rise as the speed increases, you have to increase the length of the vacation. Conversely, with slow movement, the wobler goes deeper, and here it's important not to hook the bottom if the supply of fishing line is too large.

⚠️ Warning: Never focus on the footage listed in the catalogue. The actual depth depends on the thickness of the fishing line, the availability of sailing at the bait, and even the density of water in the reservoir.

Also, the bottom type: When you catch clear sand or silt, you can safely release the bait to the maximum distance, risking only rare hooks. If the bottom is rocky, with snags or shells, using long vacations becomes dangerous, in which case experienced trollers reduce the distance to the minimum necessary to reach the working horizon, or move to more expensive, but less hooked models.

The influence of the fishing line type on the deepening and play

Choosing between a wicker cord and a monophilic line is not just a matter of strength, it is a matter of wiring physics. A wicker cord It's almost non-stretchable and has a minimal cross-section, which allows the wobbler to go to maximum depth with less release. But there's a huge disadvantage to the trolling, which is the lack of shock absorption. When you jerk or come into contact with the snag, the entire load is placed on the lips of the fish and the wobbler buckle.

Unlike the cord, monophile It's very stretchable and very sailable, and it's stretched under load, which can act as a shock absorber for catching, but it's very debilitating to control the bait, and because the line is stretched, the Wobler swims higher, and to reach the same depth as the wool weave, it has to be released 20 to 30 percent further, and this is especially true at great depths, where the count is meters.

• 🎣 The snare: The best choice for deep-sea trolling, provides clear pecking transmission and maximum depth.
• 🎣 Monophile: It is preferred for shallow water or situations where needed to depreciate the jerks of large fish, but requires more vacation.
• 🎣 Fluorocarbon: Often used as a leash material, it is less noticeable in water, but it sinks harder, which can slightly change the play of lightweight wobbles.

Many professionals use combined circuits, where the main cord is a wicker for control, and in front of the wobbler is a monophilic or fluorocarbone. leash This reduces the visibility of the tackle to the cautious predator and adds the necessary elasticity.

Classic bait arrangement schemes

When multiple rods come into play, the question of distance becomes even more acute. The main goal of the troller is to create a bait carpet that will cover the maximum area, but not get confused. fanIn this case, the central baits are released to a minimum distance, and the lateral baits are progressively increasing, which avoids overlapping even when the boat maneuvers.

There's also a ladder scheme that's perfect for catching brows and dumps, where the baits are arranged so that each one is on its own depth horizon, the near wobblers are working on the top edge of the dump, the middle ones on the slope, and the far ones are scribbling down the bottom at the foot, a tactic that allows you to quickly find the active layer of fish.

The rod's position	Length of leave (minimum)	Length of leave (maximum)	Purpose of the arrangement
Central (downrigger)	15 meters	30 meters	Point fishing at depth
On-board (internal)	25 meters	40 meters	Mid-horizon
Onboard (external)	40 meters	60 meters.	Finding active fish on the side
Outriger (far)	50 meters	80 meters	Coverage of wide waters

If you use more than three or four rods, the distance between the tips of the baits should be at least 3-5 meters. If you release the rods too close to each other, if you peck or change the course of the boat, the overlap is almost inevitable. Untangle the "beard" of three wobblers on the current is an extremely thankless and time-consuming activity.

Calculation of distance depending on depth

How do you know how many meters you have to give? Experienced anglers use a rule of thumb: to reach working depth, the fishing line must be 4-6 times the depth at the fishing point. That is, if you want to break 5 meters deep, you need to release the Wobler at least 20-25 meters. However, this rule works for standard speeds of about 3-4 km / h.

If you use downriggers, things change. The downrigger's load forcefully deepens the bait, so the length of the vacation can be much shorter -- sometimes 10-15 meters is enough for the wobler to walk in a given horizon. leave-length It is regulated more to control the game of bait and avoid overlapping than to reach depth.

And the bottom is important to consider, because when you're fishing on tables or plateaus where the depth is constant, you can let the bait go far and forget about it. But when you're going through areas with a sharp change in depth (underwater bumps, pits), a long vacation becomes a problem. You just don't have time to lift the Wobler when it suddenly becomes shallow under it, and the hook is guaranteed. In these places, it's better to keep the bait closer, actively working with an rod or a winch.

Specificity of fishing on the current and wind

Wind and current are the main enemies of precision wiring, but if you do it right, you can turn them into allies. When you go against the current, the speed of water over the wobbler increases even when the boat speed is low, which means that the bait will go higher. To compensate for this, you either have to reduce the speed of the motor to a minimum, or leave up line.

When fishing in the wind, the boat can reach high speed even at low speeds. Here the situation is reversed: the Wobler flies a bullet and pops up. In such conditions, long vacations become dangerous due to the risk of crossovers and loss of control. Often you have to switch to heavier Wobblears or use additional flywheels before bait.

⚠️ Attention: With strong side winds, the line can be pushed to the side, forming an arc, which changes the angle of attack of the wobbler and can completely knock his game, in such cases, reduce the vacation to the minimum possible.

There's an anchor trolling technique where the boat is actually anchored or anchored, and the current is bait, and here the vacation distance is regulated exclusively by the depth at the berthing point, and in these conditions, you typically let go 15-20 meters so that the ber is guaranteed to leave the turbulence zone behind the stern of the boat.

Common Mistakes and How to Avoid Them

One of the most common mistakes is to drive a Wobler to a depth by just trying to get the length of the line, ignoring the speed. A fisherman lets go 60 meters of the monophile, hoping to get the bottom, but swims at 7 km / h. In the end, the Wobler just drags into the waters, and time goes away. Remember: first set the speed to sink, and then adjust the length of the vacation.

The second mistake is ignoring visual control. If you let the wobler go 50 meters, you don't see what's happening to the bait. It might have flipped over, caught on the grass, or just stopped playing because of damage. Periodically rewind the tackle to visual contact to make sure that it's not in the right position. owl It's working properly.

• ❌ Mistake: Using a line that is too thick "just in case." A thick line creates sailing and prevents the wobbler from going deep.
• ❌ Mistake: No line counter, and without it, you'll wonder how many meters you gave last time.
• ❌ Mistake: Ignoring the line, wipe the line from oil and dirt after every trip, or it will get worse and drown.

FAQ: Frequently asked questions

Can I use one vacation for all Wobbles in the arrangement?

Theoretically, you can have all the wobblears the same and go at the same depth, but in practice, it's a bad idea. Other shapes and sailing baits will cause them to get confused. It's better to vary the length of the vacation by at least 3-5 meters between the adjacent rods.

How does the color of the line affect the number of bites?

At distances over 20-30 meters, the predator (pike, pike) rarely distinguishes the color of the line, more important than its invisibility in the water and lack of glare, so a transparent fluorocarbon or dark green wicker is preferable to bright yellow cords, although the latter are more convenient for visual control.

Should I change the length of the holiday when changing the time of day?

Yes, it makes sense. At night, fish often go to smaller places or, conversely, become more cautious. Experiments with the length of the vacation (for example, shortening the distance for more aggressive wiring or increasing for delicate wiring) can give results.

What if the Wobler constantly pops up on a long vacation?

Chances are you have exceeded the critical speed for this model or use too thick fishing line. Try to reduce the speed of the boat to 2.5-3 km / h. If it does not help - replace the fishing line with a thinner or add a mini-stucker.