Modern fishing and water tourism are undergoing significant changes, shifting the focus towards sustainability and comfort, replacing noisy gasoline units with more and more frequent ones. noiseless electric motorsThey're designed to sneak up on a careful fish without the risk of being swayed by the vibrating body. HaswingWe have established ourselves as a manufacturer of reliable and affordable solutions for small swimming craft, combining advanced control technology and time-tested design.
The popularity of these devices is not only due to low cost of ownership, but also because of the ease of maintenance, which is critical for owners of inflatable boats and small boats. You no longer have to worry about changing oil, candles or preparing a fuel mixture before each trip. Just charge the battery and you're ready to get on the water at any time. It's this balance between functionality and convenience that makes it possible to do so. Haswing electric motors One of the most popular products in its segment.
In this article, we will discuss in detail the technical features of various series, consider the nuances of installation on different types of boats and give practical recommendations for extending the battery life. You will learn how the tiller-controlled models differ from the foot-controlled systems, and how to choose the right thrust for your boat. Competent approach to the selection of equipment will avoid common mistakes and get the maximum pleasure from water trips.
Key advantages of electric motors Haswing over competitors
Analyzing the market of boating technology, we can identify several fundamental differences that put the products of this brand in a favorable position. high-energy Engineers have been able to optimize energy consumption without loss of power, which is especially noticeable when driving against the current or wind.
The second important factor is the versatility of the installation, which is that most models are equipped with telescopic lower units, which allow you to adjust the depth of the propeller immersion, which makes it possible to use the motor not only on inflatable boats, but also on inflatable boats. metal boat Or plastic boats with a transom board of different thicknesses, and the shaft design is made of strong stainless steel that is resistant to corrosion in salt water.
⚠️ Warning: Despite the presence of anti-corrosion coatings, after operating in salt water, be sure to wash the engine with fresh water. Ignoring this rule can lead to oxidation of the contacts and reduce the life of the lifting mechanism.
The third advantage is a well-designed safety system, built-in fuses and thermal sensors prevent windings from overheating during long periods of maximum rev. battery-indicator It's a tiller that shows the remaining energy in real time, allowing you to plan your return to shore.
- 🌊 Low noise and no vibrations, which is ideal for trolling.
- 🔋 Economical power consumption, increasing the operating time of one battery.
- 🛡️ Reliable protection against overloads and foreign objects entering the screw.
It is important to understand that electric motor It's not just a replacement for a gasoline unit, it's a change in the whole philosophy of water travel, and it requires a different approach to navigation and route planning, where speed gives way to efficiency and quietness. Haswing Designed to meet these requirements, offering the user a wide range of adjustments.
Overview of popular models and their technical specifications
The company's product line is extensive and covers the needs of both calm fishing enthusiasts and owners of heavier vessels. CaymanThese are mass-user-oriented engines that offer great value for money, and they are equipped with composite lower unit and tiller-controlled engines with multiple forward and backward speeds.
For those who prefer to fish standing up or need to free their hands, there are modifications with the possibility of installation. foot-pedalThis allows you to react instantly to bites or changes in the bottom relief without letting the fishing rod out of your hands. OsapianThey have increased thrust and are designed for boats up to 5-6 meters in length.
Special attention should be paid to the models with electric lift The mechanism allows a single push of a button to lift a screw out of the water to overcome shallow water or transport, which significantly reduces the physical stress on the angler and speeds up the process of preparing the boat for movement, the technical specifications of such systems often include protection against jamming.
| Model | Traction (lbs) | Voltage (B) | Weight (kg) | Type of management |
|---|---|---|---|---|
| Haswing Cayman B 55 | 55 | 12 | 10.5 | tiller |
| Haswing Osapian 80 | 80 | 12 | 14.2 | tiller/Scissor |
| Haswing Cayman G 40 | 40 | 12 | 9.8 | tiller |
| Haswing Pro Traxx 12V | 55 | 12 | 11.0 | Remote |
When choosing a particular model, you need to take into account not only the length of the boat hull, but also its full load. Motor traction It should have a margin of 20-30% for comfortable movement in the wind or current, and a lack of power will lead to a rapid discharge of the battery and overheating of the engine, which will reduce its life.
Rules for choosing a battery and calculating the time of stroke
The heart of any electrical propulsion system is the power source. Haswing The use of such batteries will lead to their rapid failure and possible damage to the engine due to voltage surges is absolutely not suitable for conventional starter car batteries, which are designed for short-term high-current return.
The best choice is traction batteries type Deep Cycle They can be lead-acid (AGM, GEL) or lithium-iron-phosphate (LiFePO4), which, despite their higher initial cost, have a significantly higher charge-discharge life and lower weight, which is critical for light inflatable boats.
Comparison of battery types
Lead acid batteries are cheaper but heavier and fear deep discharge. Lithium (LiFePO4) is 40-50% lighter, hold a charge longer and do not lose capacity in the cold, but require a special charger.
The battery life is calculated based on battery capacity and current consumption. The formula is simple: battery capacity (Ah) is divided by motor consumption current (A) at the selected speed. For example, at 100 Ah and 20 A, the theoretical operating time is 5 hours. peckert and the water temperature.
- ⚡ Use batteries labeled Deep Cycle or Marine.
- 🔌 Be sure to use a fuse in the power chain, installed as close as possible to the battery.
- 🌡️ At low temperatures, the capacity of lead batteries drops to 50%, lithium batteries are more stable.
⚠️ Warning: Never discharge a lead acid battery below 50% of its capacity. Deep discharge causes irreversible sulfation of the plates, after which it will be impossible to restore the battery.
To accurately monitor the state of the power system, it is recommended to install additional voltmeters or specialized battery monitors, which will allow you to see the real voltage under load and make a decision on returning to base in time. Battery savings It often leads to disappointment in buying the engine.
Instructions for installation and first start
The process of mounting an electric motor on a boat is quite simple and requires no special skills, but following the sequence of actions guarantees the safety and durability of the equipment. First of all, you need to choose the location of the mounting. For PVC inflatable boats, usually a transom board attached to inflatable tubes, or a rigid transom.
Make sure the mounting surface is flat and able to withstand the weight of the motor along with the battery. Haswing It is used by means of strings, which must be tightened with sufficient force to prevent displacement, but without damaging the transom material. It is recommended to use rubber gaskets between the metal elements of the rods and the boat hull.
☑️ Check before the first launch
The battery is connected through special terminals that come with the kit. It is important to observe the polarity: red wire to plus (see below).+), black to minus (-An error in polarity can disable the electronic control board, as not all models have a sway protection. After connecting, check the tension of the cable - it should not interfere with the operation of the pump.
The first run is best done on land, in a container of water (bucket or barrel) to make sure that the screw is rotating correctly and there is no extraneous noise. Immerse lower unit in water at least 25-30 cm to avoid cavitation and splashing. Smoothly rotate the romple and choose the speed, watching the flow of water.
If the motor is equipped with a system electric liftBefore the first use, it is recommended to raise and lower the lower unit several times so that the lubricant is evenly distributed in the mechanism, and it is also worth checking the operation of the speed limiters so that the mechanism does not go to the extreme position with effort.
Maintenance and care of the electric motor
Regular maintenance is the key to a long and trouble-free operation of your HaswingThe main element that needs attention is the screw, and before each step, visually inspect it for cracks, chips, or winding fishing line, and a line that falls on the shaft can damage the glands, causing water to enter the inside of the lower unit.
Once a season, or more often when active in salt water, it is recommended to prevent moving parts. You need to lubricate the hinges of the inclination and rotation of the motor with a special lubricant that is resistant to washing out with water.
If you keep the motor in your garage or house in the winter, don't leave it in a fully compressed or fully decomposed state. It's best to lock the lower unit in the middle position to avoid deformation of the springs of the lifting mechanism.
Special attention should be paid to electrical contacts. Battery terminals and wire connections should be clean and tightly tight; oxidation of contacts leads to a drop in voltage and heating of connections, which can cause fire; Periodically check the insulation status of the cable for scuffling.
- 🧼 After each fishing, wash the engine with fresh water, especially if you fished in a salty pond.
- 🔧 Once a year, change the lubricant in the gearbox (if the design provides for the maintenance of the gearbox).
- 🔋 Keep the battery charged even if the motor is not in use for a long time.
In case of unusual hum, vibration or burning smell, operation must be stopped immediately. Diagnosis of malfunctions It avoids expensive repairs early on, and often the problem is a worn screw or debris that gets inside.
Comparison with gasoline analogues and economic efficiency
Many anglers still question whether to switch to electric power. Let's look at the economics of the issue. The cost of owning a gasoline engine is the price of the unit itself, the fuel, the oil, the candles and the periodic maintenance. Haswing It only requires electricity to charge, the cost of which is incomparably lower.
And then electric motors require little maintenance in the off-season, no need to preserve the engine for the winter, no need to drain fuel or add stabilizers, and just storing it in a dry place is all the requirements, and it saves not only money, but also time.
Over 5 years of operation, fuel and maintenance savings when switching from a gasoline engine of 2-3 hp to an electric motor Haswing is more than 70% of the initial cost of an electric kit (motor + battery).
The environmental aspect is also important: the lack of exhaust gases and fuels makes electric motors ideal for use in protected areas, on paid water bodies with strict environmental requirements and simply for those who value clean nature. Silence It is also a key factor in allowing you to hear nature and yourself, rather than the roar of the motor.
⚠️ Note: When calculating savings, consider battery life: Lithium batteries pay off faster with more cycles, whereas lead batteries may need to be replaced after 2-3 years of active use.
So for small boats up to 5 meters long, the electric motor is the ultimate leader in terms of performance, providing comfort, reliability and economy that are not available for low-power gasoline counterparts. Haswing This is an obvious solution for modern fishing.
Frequently Asked Questions (FAQ)
Can a Haswing electric motor be used in salt water?
Yes, most models. Haswing They are corrosion-proof and are designed for use in salt water, but after each exit, the engine must be thoroughly washed with fresh water to prevent the formation of salt deposits on metal parts and electrical contacts.
What is the maximum speed of an electric boat?
Speed depends on a variety of factors: the length and shape of the boat hull, loading, wind and current strength. On average, a 55 lbs electric motor is able to accelerate a lightweight PVC boat to 5-7 km / h. This is a cruising speed, optimal for movement and trolling, but not for high-speed glides.
Do I need to register a boat with an electric motor in GIMS?
According to the current legislation of the Russian Federation, small craft with an engine of more than 8 kW (about 10.8 hp) are subject to registration. Haswing significantly below this threshold (usually up to 1-1.5 kW), registration of the boat itself with such a motor is usually not required if the total weight of the curb vessel does not exceed 200 kg.
What to do if the engine loses power?
The power loss is most often due to battery discharge or contact oxidation. Check the voltage on the battery terminals under load. If the battery is charged, check the screw for damage or winding of foreign objects. Also, the problem may be the wear of the engine brushes (for collector models) or a malfunction of the control board.
Are Haswing engines compatible with other manufacturers?
In most cases, screws Haswing They have a specific shape of the sleeve and seat, so the installation of screws from other brands (for example, Minn Kota or Watersnake) may not be possible without improvements or adapters.