Boat Fishing: a complete guide

Hunting predators using towed baits, popularly known as “track” or “drag” fishing, remains one of the most extractive methods of fishing in large bodies of water, which allows you to quickly catch vast areas, finding active flocks of pike, perch or perch where the spinner from the shore simply can not reach. Success here depends not only on luck, but also on the correct preparation of the boat, the choice of baits and understanding the hydrodynamics of wiring.

Unlike classic trolling, where several rods with coils are used, classic rods involve the use of one or two spinnings rigidly fixed on board, or even catching on the finger with the control of the tension of the fishing line. Depth of immersion The bait is regulated by the length of the holiday and the speed of the boat, which requires constant attention and a sense of tackle from the angler. The right gear allows you to simulate the movement of the injured fish, provoking the predator to attack even during periods of low activity.

Modern materials and technology have greatly expanded the angler's arsenal to make this type of leisure more comfortable and efficient. However, the basic principles remain the same: predators respond to movement, vibration and shine. In this article, we will examine all the intricacies of the process, from choosing a boat to the final catching of the trophy, so that your fishing always ends in a full cage.

Selection and preparation of craft

The basis of successful red tape fishing is the right boat. PVC boats Hard bottom (HBB) is preferable because it provides better course stability and allows you to confidently install rods in the holders without the risk of their falling when rolling. Metal boats ("Kazanki", "crowberry") are also effective, but require a more powerful motor and create more noise when in contact with the wave, which can deter cautious fish.

The key is the stability of the hull, and when wiring the bait with jerks or at different speeds, the boat should not prowl too much from side to side. kylson Or inflatable keels help to keep the course, especially in lateral winds, and it is also important to consider the possibility of installing transom rod holders or on-board outriggers that will allow you to spread the baits to the sides, avoiding the overlap of the fishing line.

⚠️ Warning: Never install rod holders directly on inflatable tubes without a rigid platform. With a strong pull of fish or a hook, the rod can penetrate the balloon, leading to an emergency on the water.

To control speed, which is a critical parameter in the catch of red tape, you need a motor that can adjust the speed exactly. Electric motors here often beat gasoline engines because they can work at minimum speeds without decelerating. outboard motorMake sure its idling range allows for speeds of 2-4 km/h, which is often optimal for wiring wobbles.

Equipment: rods, coils and lines

The choice of gear for fishing for red tape is dictated by the need to constantly monitor the bait and withstand high loads when catching. The rod must be powerful enough to cope with a large pike or pike, but also have a sensitive tip for registering cautious bites. The optimal test form is from 20 to 60 grams, and the formation is fast or medium-fast. The length of the rod usually varies between 2.1 and 2.4 meters, which is convenient for placement in a boat.

The coil must be reliable and roomy: the angler is the choice of the 3,000-4000 Shimano type of non-inertial models or the heavy-duty animators. Multiplier coils Often preferable for serious trolling, as they are better to lay the line under load and have a powerful friction. However, a quality "inertion" with a good cord laying will also do a great job of a red tape.

The main working cord is a wicker line (PE) with a tear load of at least 10-15 kg. The wicker is not stretched, which allows you to instantly transfer the jerk to the hook and feel the touch of the bottom bait. Monophile fishing line is used less often, mainly for fishing at great depths, where additional stretchability is required to cushion the jerks, but it sails on the flow.

• 🎣 fluorocarbon leash Mandatory when catching pike, its length should be at least 30-40 cm.
• 🎣 vertebrate high quality will prevent twisting of the fishing line, especially when using rotating gloss.
• 🎣 carbine It should be large and reliable so that baits can be changed quickly even in gloves.

Lures: wobblers, splashes and silicone

The range of baits for hauling is huge, but the top spot is certainly the Wobblears, who have their own game, create powerful acoustic vibrations, and allow you to precisely match the wiring horizon. crank for active fish, minnow for passive, and shed The most important parameter of the wobbler is its working entrenchment, which must correspond to the depth at the fishing site.

Fluctuating lures are classics that are not lost in relevance. Large spoons and specialized trolling bleach work great on pike and perch at great depths. Their advantage is their long-rangeness and ability to work at different speeds. Silicon baits on jig heads or shipped with cheeburash are also effective, especially when you need to catch a bottom layer with relief.

Type of bait	Target fish	catching horizon	Feature
Wobler-minnow	Pike, Sudak.	Medium/Deep	Playing with jerks requires pauses
Wobler-crank	Perch, Pike.	Anyone.	Active own game, making noise
swayer	Pike, Trouille.	Deep.	Stable on the current, long-range
silicone	Sudak, Som	Done	Point-on terrain

When choosing the color of the bait should be guided by the rule: in clear water and sunlight, natural, translucent tones work better. In murky water or at depth, bright, "acid" colors and lures with foil elements are more effective. Acoustic noiseThe wobbler is often more important than its visual appearance, attracting a predator from a long distance.

The secret of the "companions"

Wobblers, which are made up of multiple segments, create a more sweeping and realistic game that mimics a wounded fish, but they require more delicate wiring and slower speed, or they can fall into a tailspin.

Search tactics and wiring technique

The strategy is to comb through the promising areas: the brooks, the dumps, the boundaries of grass and clean water, the boats must move against or across the current so that the bait goes naturally. The wiring speed is experimentally selected: start with a minimum and gradually increase until the bait game is optimal. Often a change of pace or a short stop of the boat provokes an attack.

When you pass over underwater obstacles, you need to be ready for an instant reaction. If you feel frequent slaps on the bottom, you should raise the rod a little or add gas to bring the Wobler to the upper horizon. In shallow water, use baits with minimal depth, so as not to collect grass and not to scare the fish with blows to the ground. echoer in this case is an indispensable assistant, showing the relief and presence of fish.

• 🚤 Move zigzag along the eyebrow to change the angle of bait supply.
• 🚤 Make periodic stops of the motor, giving the bait to float or sink (for suspensions).
• 🚤 When fishing on the current, release the bait further so that it comes out on the working horizon.

It's important to remember safety and navigation. Don't go over other boats or swimming. If you're catching two people, you can split the roles: one controls the motor and follows the course, the other controls the gear. When you're hooked, don't pull the boat back at full gas, it can break the spinning or damage the bait.

⚠️ Warning: When fishing in a snag, always have a wrench or powerful cutters on hand. Trying to pull out a stuck wobler by force often leads to the breakdown of expensive gear or the loss of a whole supply of baits.

Catching and conservation

When you bite, it's important to keep the fish from going into the snags or the grass. When you catch redheads, the cutoff is often automatically due to the tension of the line, but a short rod will not interfere. You should catch large fish confidently, but without jerking, trying to keep the cord stretched. If the fish goes deep, use fan fishing: smoothly drive the rod from side to side, tiring the predator.

Getting fish into the boat is a critical moment. For a large pike or perch, be sure to use suckerTrying to take fish with your hands or with a bumper can result in injury or descent. If the fish has swallowed the hook deeply, use an extractor or clip to extract it, minimizing damage. To keep the catch alive, use a special cookie attached to the side at a sufficient depth.

After catching the trophy, let the fish rest before the next throw. Adrenaline, splashed during the fight, takes time to recover. Check the condition of the fishing line for scuffs, especially if there was contact with a shell or snags. The damaged area is better to bandage or replace the entire reel, so as not to risk the next trophy.

Common Mistakes and How to Avoid Them

One of the most common mistakes of beginners is the wrong speed: too fast wiring causes the Wobler to go above the working horizon or to lose the game, and too slow does not attract an active predator. Constantly vary the speed and watch the "breathing" of the spinning tip should vibrate rhythmically. If the vibration is lost, then the bait has stopped working.

The second mistake is ignoring the weather, and in calm and bright sun, fish can be passive and go deep, requiring a longer vacation and deep-sea models, and in windy waves, the predator goes out into shallow water, and you need noisy, bright lures. Atmospheric pressure It also affects the bite: sudden jumps usually reduce the activity of fish.

After every fishing trip, especially on salt water, you need to wash the coils and metal parts of the gear with fresh water. Sand and salt quickly disable bearings and mechanisms. Regular lubrication and inspection of knots are the key to the long service of your equipment.

Which fishing line is better to choose for a beginner: a wicker or a monophile?

For haul fishing, especially for wobblers, the wicker cord is the only option. It doesn't stretch, so you can feel the lightest bait touches to the bottom and make instant cuts. The monophile line stretches, which lubricates the wobblear game and makes it difficult to control depth. The only time you can consider a monophile is fishing at depths of more than 10-12 meters, where sailing becomes a problem, but this is the lot of experienced pros.

Can you catch a squirrel from an inflatable boat without a motor?

Technically, you can use oars, but it's extremely inefficient and tedious. You need a constant, uniform speed to wiring a wobbler, which is difficult to maintain when rowing. You can't control the spinning when holding oars. You can't control the spinning. You can use a motor (gasoline or electric) to get rid of the wobbler, which leaves your hands free to control the tackle.

What if the Wobler constantly overhangs the fishing line of the neighboring rod?

The overlaps are caused by the rods being too close or the wrong angle of installation. Spread the holders as wide as possible on the sides. Use different baits on different rods. It also helps to install special struts (outriggers) or use fishing lines of different diameters/colors to visually monitor their position in the water. Release baits for different lengths.

Do you need a sonar to catch red tape?

The sonar is not strictly mandatory, but it improves fishing efficiency by many times. It allows you to see the bottom relief, detect driftwood (to avoid being without baits), and, most importantly, see the reaction of the fish to the passage of the bait. Without the sonar, you act blindly, relying only on experience and intuition. For a serious approach to fishing for red tape, the GPS sonaroscope is the number one tool.

What is the optimal speed of a boat for pike fishing?

The optimum speed varies from 2 to 5 km/h depending on the activity of the fish, the water temperature and the type of bait. In summer, in the heat, the pike often prefers slow wiring (2-3 km/h). In autumn, during the languor, the speed can be increased to 5-6 km/h. The key point is to watch the wobbler play: if it begins to corkscrew or vibrate unnaturally, the speed should be reduced.