With the onset of cold weather, when the water becomes clear, and the fish goes to deep brows, many spinning players switch to the water. jig-fishingBut the classic jig doesn't always work, especially when the predator is passive, and it's at those moments that boat fishing comes to the fore, allowing for the most efficient capture of complex terrain, which requires precision and an understanding of hydrodynamics, but often exceeds expectations.
Use of use egg-suck or pear As a feeding cargo, you can hold the bait at a precise point, which is critical when you're fishing for a pike or a bearch. Unlike onshore fishing, where the current is defying the tool, you can get across the jet from the boat and control the position of the cargo. Fishing in the plumb Or in the halves becomes a high-precision tool that turns fishing into a process with predictable results with the right approach.
The main advantage of this method is that it can quickly change the horizons of the fishing and explore different layers of water. You don't have to constantly re-throw the gear, just change the length of the fishing line or the angle of the rod, this is especially true at great depths, where every meter matters. Let's figure out how to properly prepare the tackle and choose a place.
⚠️ Attention: When fishing on the current from the boat, strictly monitor the position of the cord relative to the sides and screw of the engine to avoid overlapping and loss of expensive equipment.
Selection and preparation of gear for fishing from the boat
The basis of successful fishing is properly assembled extensionerThe boat does not require long spinnings to catch eggs; on the contrary, it is most convenient to use short whips ranging in length from 1.8 to 2.4 meters. The rod test must correspond to the weight of the load used, which can reach 60-80 grams or more during the course. The nod or tip of the rod should be stiff enough to signal a peck, but not bend under the weight of the cargo in the water stream.
The coil is secondary, but it has to be reliable. inertial It's a very simple model or a little bit of 2,000-3,000, and the main requirement is a smooth ride and no backlashes, because bait requires a constant brush. monophilicThe slats are 0.25-0.35 mm in diameter, as they are less noticeable in water and have minimal sailing compared to the slats, which is important in lateral winds.
The most important element is the construction of the cargo. Egg. It's a lead casting with a hole in the middle through which the main line is passed, and below the load, a stopper and a vertebral are placed, to which a leash with hooks or a squirrel is attached, and this design allows the line to slide freely inside the cargo when cut, which ensures that the predator's mouth can be reliably penetrated even from a long distance.
- 🎣 The rod: Short spinning or specialized angler for steep fishing, test up to 100 grams.
- 🧵 Leska: Monophile 0.28-0.35 mm for cushioning of jerks of large fish and low visibility.
- ⚖️ Cargo: Lead egg or pear weighing 40-80 grams, depending on the strength of the current.
- 🪝 Hooks: Offset or doubles, the size is selected for the size of the expected mining and bait.
Tactics of finding fish and choosing a parking place
Fishing on eggs from a boat is impossible without prior prospectingThe predator, especially the pike and the berches, is bound to the anomalies of the bottom, and you need to find the extremes of depth, the piles, the eyebrows, the underwater uplands, and the use of the sonar becomes a must, because you can't visually determine the structure of the bottom at a depth of 6-10 meters. Look for places where the depth varies from 4 to 8 meters in a short area.
Once a potential location is found, you need to anchor properly. cross-current Or at an angle of 45 to 60 degrees to the jet, so that the tooling would be blown away from the boat, but it would remain in the snare zone. If you stand along the current, the line would get tangled around the anchor ropes, and the angle of attack of the bait would be unnatural. The anchor shaft should be long enough to allow for rigid fixation, but allow maneuvering if necessary.
It's important to consider the direction of the wind and its effect on the position of the boat. Often the wind blows in one direction and the current carries in the other, creating a difficult situation for anchoring. In such cases, experienced anglers use two anchors, stretching the boat like a stretch, this allows a stable position and does not frighten the fish with a constant shift of shadow from the boat. The ideal position is when the boat is upstream from the catchable brow, and the tooling is blown exactly to the dump.
⚠️ Attention: Never anchor in the waterway of navigable rivers. It is life-threatening and prohibited by shipping regulations. Choose places near a coastal dump or on waterings away from the main boat path.
Fishing and wiring equipment
There are several basic methods of wiring, but the basic method is the smooth-swing... Once the load is lowered, the angler makes a smooth lift of the rod by 30-50 cm and also gently lowers it back, at which point the load is detached from the bottom, and the flow of water begins to play with the bait, giving it attractive to the predator fluctuations, the amplitude and speed of movement are selected experimentally depending on the activity of the fish.
The second option is vertical-wiringYou take the load off the bottom with a sharp swing, then you let it plan down freely, periodically stopping the rod from falling, and this technique works well on a passive perch, which prefers to attack prey that is slowly sinking in the bottom layer, and it is important to feel the bottom touch so that you can start a new wiring cycle in time.
The third method is flounderingIf the sonar shows fish gathering in the middle layers, rather than the bottom, the load is lifted to the appropriate depth and the fishing line is fixed, then a slight shivering or slight twitching is performed, which requires high concentration and constant depth control, because the current can gradually degrade the tooling, changing the fishing horizon.
☑️ Checklist of correct wiring
Seasonal features and choice of baits
The choice of nozzle depends on the season and the preferences of the local predator. In winter and early spring, when the water is cold, the fish prefers animal nozzles. lively (top, tulle, sander) put behind the back or lip, and cutting fresh fish, lard, worms and even the eye of perch works just fine, and the bait must be fresh and smell.
During the summer, when the water is warm, the predator becomes more picky, and during this time, fishing for eggs from a boat is often done using artificial baits: silicone-tailedThe color of the bait matters: in clear water, natural tones (green, brown, transparent) work better, and in cloudy water, bright, fluorescent (salad, orange).
Special attention should be paid to the size of the hook and the bait. A large pike can ignore too much bait if it is not in the active gyre phase. So have different tooling options in your arsenal. Change the size and color of the bait every 15-20 minutes if there are no bites. Often, changing the white fry to a red worm or a narrow strip of fish makes a difference.
| Season. | Priority bait | catching horizon | Predator activity |
|---|---|---|---|
| Winter (deaf-witness) | Moth, squirrel, baby | The bottom layer | Low, it takes a game. |
| Spring (pre-nest) | Worm, babe, lard | Average depths | Tall, corny. |
| Summer. | Silicone, bait, crawl. | Flowers, eyebrows | Average, electoral |
| Autumn (Jor) | Big veal, vibrating tail. | Deep pits | Very high. |
The secret ingredient for cold water
During periods of deafness or mild bite, try using blood or garlic-based attractants. Apply a little spray on the bait before casting - this can provoke an attack even by a passive predator.
Error analysis and professional advice
One of the most common mistakes of beginners is to use too rough tooling: thick line and large hooks can scare off careful fish, especially in clear water. Thin tackle It allows you to do more natural wiring and less sailing on the flow. Don't be afraid to use a line of 0.22-0.25 mm, if you are sure of the quality of the nodes and the lack of hooks.
The second thing is noise. Boat fishing involves finding the fisherman in close proximity to the fish. Loud talk, bumps on the side, the sound of the anchor chain, all of which scares away the underwater creatures. Move smoothly, whisper and try to minimize the outside sounds. Remember, water is a great vibrating force.
Many people ignore the importance of constant monitoring. catch-horseThe current can change its strength, taking your bait too high or pressing to the bottom. Constantly check the depth, lowering the load to the touch, and adjust the length of the fishing line. Fishing is a constant process of analysis and adaptation to changing conditions.
Use a bright float bead on the fishing line above the load, which will help you visually monitor the position of the gear in the water and notice even the most careful bite on the movement of the bead.
Security and legal aspects
Boat fishing, like any other type of aquatic fishery, is regulated by law. Be sure to check the fishing rules for your region before you leave. There are no spawning regulations, restrictions on the number of hooks and the minimum size of fish caught. Using more than a certain number of hooks per angler can be considered poaching.
Water safety is priority number one. Even on a warm day at depth, water can be cold and current strong. Having life jackets for every person on the boat is a requirement, not a recommendation. Also check for a scoop, anchor with a reserve of rope and the serviceability of the boat. The mobile phone must be charged and in a waterproof bag.
Respect nature and other anglers. Don't take other people's sedated places, don't make noises next to other boats, don't leave garbage behind. Keeping waters clean is our job, and it's only by working together that we can save fish wealth for future generations.
⚠️ Attention: During spawning bans, fishing from any means of swimming (other than motor, if permitted, or even prohibited) is often restricted, and check the current dates of the ban at your local fishery department to avoid heavy fines and confiscation of gear.
The key to success in egg fishing is the constant search for active fish and the ability to quickly adapt the weight of the cargo and the game of bait to the current conditions of the predator’s flow and mood.
Frequently Asked Questions (FAQ)
What is the optimal weight for a medium-flowing river?
For an average current at depths of 5-8 meters, a load weighing 40-60 grams is usually enough. If the current is amplified or the boat is heavily demolished, the weight can be increased to 80 grams, but try not to overload the gear so as not to lose sensitivity to bites.
Can I use a wicker cord instead of a fishing line?
You can use a braid, but it has its downsides: the wicker cord is very grazing in the wind and current, which makes it difficult to control the tackle, and it better transmits fish jerks, but it cushions worse, which can lead to a large fish coming off or a lip cliff, and for beginners, a monophilic fishing line is better.
How often should I change the bait?
Live bait (fry, worm) should be changed as it is damaged or lost attractiveness. On a strong current, the young can quickly lose sight. Artificial bait is changed if they stop working or if the fish no longer responds to a given color and size. The average interval is 15-20 minutes of unsuccessful fishing.
Do I need to feed the place when fishing for eggs?
Classical egg fishing is often done without bait, as the gear itself involves finding active fish. However, using a dump feeder or periodic feeding (chopped worm, cake) can help keep the fish in the fishing area, especially during the course where the food is quickly eroded.
What if the load is constantly stuck in the stones?
If the terrain is heavily encrusted or rocky, try to reduce the length of the leash or switch to a gear with a drain leash, where the load goes separately, you can also use cargo-unlocks or go to catch in the halves, not lowering the load to the bottom, but playing 10-20 cm from it.