Boat Fishing opens up completely different horizons for anglers, which are not accessible to coasters, and the ability to get close to a promising brow, feed a point on a deep plateau or catch a reed bay requires a specific approach to equipment. boat-rod They are focused on vertical wiring, depth control and work in a limited cockpit space.
The right gear allows you not only to catch trophies comfortably, but also to effectively manage the process of catching in high winds or currents, there is no place for universal sticks, which are good everywhere, but nowhere perfect. The fishing rod It should be light enough not to tire your hand when playing constantly, and sensitive enough to pass every touch of the fish. In this article, we will discuss the nuances of choosing fishing rods for different types of fishing, from active trolling to delicate plumb fishing.
In water where there is a high probability of overboard or impact, reliability becomes a critical factor. Modern composite materials allow you to create gear that combines strength and minimal weight. Understanding the physics of the fishing process from the board will help you avoid annoying errors and empty trips.
Specificity of onboard fishing and requirements for gear
Boat fishing is fundamentally changing the geometry of the fisherman-fish interaction, and the angle of entry of the fishing line into the water is almost vertical, requiring a review of the test and rod structure requirements. Flight fishing rods They're often smaller, usually 1.5 to 2.4 meters, because of the size of the boat, and there's just nowhere to turn in a narrow PVC boat, especially if you're both catching.
The key is whip sensitivity, and when you're squirting or rat fishing, you need to feel not only the bait, the bottom, the structure of the ground, but also the bait, the sticky tops, or the whole graffiti. Hardness of lump at the same time, it should allow you to confidently cut the fish at a depth, where the stretchability of the fishing line affects.
ā ļø Attention: When using heavy loaders or deep-sea wobblers, watch the load on the form at the time of cutting. The vertical position of the rod creates a lever that can break a thin top when a sharp jerk is made.
It's also important to consider the operating conditions, because the equipment is in constant contact with water, exposed to ultraviolet light and salt spray. Reel holders They have to be made of corrosion-resistant materials, and the bandwidth rings have a high-quality coating that is resistant to abrasion by wicker cords, and cheap models quickly fail, losing their functionality.
Spinning for trolling: power and reliability
Trolling is one of the most preying ways to catch a predator, but it places extreme demands on tackles. The rod here operates at constant tension, resisting the pressure of water on the wobler and fishing line. Trolling spinning They are distinguished by a powerful kettle, reinforced fittings and, as a rule, have a test from 40 to 200 grams and above. The length of such rods varies from 1.9 to 2.7 meters, which allows you to effectively practice fish jerks.
For serious trolling, specialized models with a built-in fishing line counter or the possibility of installing a large multiplier coil are often used. The form must have a parabolic or complex structure to extinguish the sharp jerks of a large pike or catfish without pulling the bait from the mouth of the fish. Naval series rods are preferable to freshwater because of increased protection against corrosion.
The handle is an important element, and it should be made of water-free materials (EVA, neoprene) and be elongated to allow a comfortable abdominal position for catching trophies, and it is not advisable to use short stumps here because the control lever is lost.
- š£ Test: Choose with a margin, taking into account the resistance of the wobbler at a speed of 3-5 km / h.
- š£ Rings: Only reinforced, on one leg, with SiC ceramics.
- š£ Build: medium-fast or slow for the depreciation of jerks.
- š£ Length: 2.1ā2.4 m is optimal for ease of work in the boat.
When trolling at depths of more than 10 meters, use downriggers or outriggers to spread baits horizontally and avoid overlaps.
rods for plumb fishing and vertical flickering
This class of gear is most popular among lovers of winter fishing, switched to the summer period, as well as among those who hunt for perch and bearsh. Fresh fishing rods They resemble enlarged winter balalaikas or short spinning forms 0.6-1.2 meters long, their main task is to ensure a rhythmic play of bait and a clear fixation of the bite.
Designably, they can be telescopic or plugged. Telescopes are smaller and more convenient to transport in a box, but plug models have better tactile sensitivity and reliability. Blastics are often nodded or hypersensitive on their own. Tighter models are used to catch on the current, allowing heavy mormy.
Japanese stand out tanago And specialized "sabic" rods that have a unique system of rings that are located along the entire length of the form, which prevents overlapping with a sharp swing, which is critical when catching active fish when the count is seconds.
| Type of catch | Length (m) | Test (g) | Features |
|---|---|---|---|
| Sudak/Bersch | 0.6 - 0.9 | 10 - 40 | Sensitive whip, nod |
| Perch | 0.5 - 0.7 | 1 - 15 | Lightness, balance. |
| Pike (large) | 0.9 - 1.2 | 20 - 60 | Powerful comet, reliable rings |
| Breath (on the ring) | 0.6 - 0.8 | 30 - 80 | Short move, hard cut |
Secrets of the nod for sheer fishing
The nod should be matched to the weight of the bait so that in the working position it deviates by 30-45 degrees. Too soft nod will not give the desired amplitude, and a hard one will hide a cautious bite. The ideal material is lausan or a metal plate with a coating.
Flight fishing rods with a nod: classics for bream and carp
Boat Fishing on the current is a separate art that requires specific gear. Flight fishing rods For this type of fishing, often called "rings" or fishing rods for wiring from an anchored boat, they are short (0.5ā0.8 m) hard whips with a large coil or motovilka.
The key here is to be able to hold the tooling in a strong current and to fix the bite, and the nod in these gears is not only a signaler, but also a shock absorber. Bream fishing rods are often used with a flexible whip, which acts as a nod itself, which simplifies the design and increases reliability.
These rods are often made of fiberglass or composites, they're cheap, they're not afraid of impact or water, they're used less because of their fragility when they're handled in a cramped boat, but there are high-module carbon models for sport fishing that offer incredible lightness.
- š Coil: It should have a reliable brake-rattle.
- š Whip: fiberglass or composite, not afraid of blows.
- š Kiwok: long (20-40 cm) for smooth wiring.
- š Fixing: Possibility of installation in the holder on board.
ā ļø Warning: When fishing on a strong current, never tie the line tightly to the nod without the possibility of a quick reset. A sharp jerk of a large fish or a hook can drag the gear overboard along with the fishing rod.
Choosing a coil and fishing line for boat tackle
Wearing is a system where the rod and the coil work in pairs. For onboard fishing, the size of the coil is often dictated by the balance of the entire system. Non-inertional coils The sizes of 1000-2500 Shimano are ideal for lightweight spinning and nod fishing rods, providing a smooth line and easy throwing (if required).
For trolling and heavy bottom fishing are indispensable multipletThey have tremendous traction power, they allow you to use thick cords, they don't twist the line, and having a line counter on the coil is a huge plus for trolling, so you can get back exactly to the feeding points.
The choice between a line and a wicker cord depends on the task.PE) is not stretchable, which gives better sensitivity and cutting at depth, but it is more noticeable in water and can saw hands. Monophile fishing line cushioning jerks and less noticeable, which is important when catching cautious fish in clear water.
āļø Checking tackle before departure
Tactical nuances and safety on the water
Having the right gear is half the battle, and success depends on being able to use it in a particular setting, and when you're fishing from a boat, it's important to anchor properly. Anchor system It should allow you to quickly change position or, conversely, to rigidly fix the craft. Using two anchors (in the nose and stern) allows you to stand across the current, which is ideal for catching eyebrows.
Safety is paramount. Sharp hooks, heavy loaders and a swinging boat are a dangerous combination. Always have an extractor and yawner on hand to quickly release the fish without injuring either the fish or yourself. It is also recommended to use a safety rope for tackles, especially when fishing alone.
Don't forget the sonar. gadgets And so you can see not only the bottom relief, but also the fish's response to your bait, and real-time rod adjustments based on sounder data increase catch rates.
ā ļø Warning: Never get up in a boat during a strong wind or wave, even if you have the most stable gear in your hands. A sharp roll can lead to a fall overboard or a boat tipping over.
The main secret of successful fishing from a boat is not the length of the rod, but the ability to accurately position the boat above the fishing point and maintain this anchor even when the wind is amplified.
Frequently Asked Questions (FAQ)
Can you use a regular spinning for fishing in plumb?
Technically, you can break off a comet or use only the top, but it's not effective. Normal spinning is too long and heavy for constant brush play. Better to buy a specialized fishing rod up to 1 meter long.
Which rod test to choose for trolling on Onega?
For Lake Onega and other large bodies of water, where large pike and salmon are found, rods with a test of 50 to 150 grams are optimal, which will allow you to conduct large deep-sea wobblers and confidently fight trophies.
Do I need a boat ride when Iām fishing?
It is dangerous to pull fish, especially pike or pike, on board with your hands (you can hurt or drop fish).
How to store fishing rods in a PVC boat during the transition?
Use special tubes or soft covers, and fold the rods along the side, fixing them so that they do not roll along the bottom and damage the cylinders with the rest of the equipment.