Catching bream from a boat: complete tactics and equipment

Capturing a large bream from a boat opens up opportunities for fishermen that are not available in coastal fishing. Unlike stationary fishing on the shore, the boat allows you to reach deep pits, brows and tables where trophy individuals that ignore shallow water feed.

The key advantage of this approach is the possibility of spot catching promising zones without the need for long-range casting, which often carries the feeder with the current. Fishing bream from a boat It requires specific gear training, the choice of proper anchoring and an understanding of the behavior of fish under pressure on water.

In this article, we will take a look at all aspects of onboard fishing, from the choice of boat to the intricacies of feeding a point, you will learn how to properly assemble bottom gear and why vertical feeding of the nozzle is often more effective than classic casting.

Search for perspective places and navigation

Ninety percent of the success of fishing depends on the right location. Breath is a schooling fish and tied to the bottom relief. When you're in a boat, you get the unique opportunity to tap the bottom with a sonar or marker load to find sharp changes in depth, so-called "falls of depth". dump and watering.

Most often, bream flocks are at the exit of pits or on a plateau adjacent to the riverbed, and it's important to look for places with a hard, but not rocky bottom, often covered with shells or colonies of draissen, and this is where the fish finds their main food.

When looking for a place, consider the direction of wind and current. Bream prefers to stay on the border of calm water and moderate flow, where the current is blowing away forage. On rivers with strong currents, look for places behind obstacles where the turns or whirlpools form that carry forage.

⚠️ Attention: When fishing on a strong current, avoid placing the boat across the jet. This creates a sailing effect, tears the anchor and frightens the fish with constant strain of gear. Always become a nose or a stern to the current.

Using a sonar allows you not only to find depth, but also to see a thermocline, a layer of water where the temperature changes dramatically. Breaths often stand just above or below this layer depending on the time of day and season. Accurate navigation by GPS coordinates of successful points will allow you to return to them on subsequent fishing trips.

Equipment and choice of tackles for the board

Boat gear is very different from shore gear, you don't need long rods for long-distance casting, you're going to have a blank that's 1.5 to 2.1 meters long, and you're going to get in the way of the boat, you're going to get stuck on the side, and you're going to get uncomfortable when you're out.

The fishing is done with a side fishing rod or short feeder rods with a dough corresponding to the weight of the feeder and the strength of the current. The coils are used with non-inertial sizes of 3000-4000 or powerful multipliers. The main requirement is the reliability of the friction and the forest timber.

As the main line, it is better to use a wicker cord with a diameter of 0.12-0.16 mm. The wicker does not stretch, which gives excellent sensitivity even at depths of 10-15 meters and allows you to clearly feel the bite. Monophile line at such depths would turn into a spring under pressure of water.

• 🎣 The fishing rod Ideal for vertical fishing, compact and sensitive.
• 🎣 nod The mandatory element signaling a bite is often made from a clockspring or lausan.
• 🎣 Feeder - metal mesh or plastic container for the delivery of feed to the bottom.

The tooling also has its own features: often used paternoster or Gardner loop, but in a shortened version. Leash length varies from 30 to 70 cm depending on the activity of the fish and the transparency of the water. The more careful the bream, the longer the leash is required.

Tactics of anchoring and stabilization of the boat

The right way to set the boat is the foundation of successful fishing. The bream is a careful fish, and the constant tugging of the boat from the wind or current will be transmitted through the fishing line to the hook, scaring off prey. There are two basic anchoring patterns: nose to flow and stretch.

The nose-to-current option is applied to rivers with moderate to high currents of water, the boat becomes in the stream, creating minimal resistance, the anchor fall must be triple depth at the fishing site for reliable retention, while the gear is lowered strictly vertically or with little demolition.

The stretching pattern (two anchors) is used on reservoirs, lakes or side winds, one anchor holding the nose, the other anchoring the stern, or anchoring diagonally to fix the position above the point, which allows you to fish as comfortably as possible without turning your whole body around.

It is important to use positive buoyancy anchor ropes or to supply them with buoys so that they do not get entangled in the engine propeller. The length of the ropes should allow the boat to cushion the water jerks, but not to move beyond the fermented spot.

To further stabilize in windy weather, you can use a floating anchor (parachute), which is mounted from the bow of the boat, which extinguishes the vibrations of the hull on the wave, making fishing more comfortable and bites more noticeable.

bait: composition and technique of feeding

Without proper feeding, fishing from a boat becomes a lottery, and the angler's job is to create a dense forage table at the bottom that will hold the pack but not fully saturate it, and because we fish vertically, the food must be delivered exactly under the boat.

This uses dump truck feeders or net containers on a separate cord, and the feeder is stuffed with porridge (milk, barley, peas) with flavours and sinks to the bottom just upstream from the tackle holes. The current washes away the feed particles, creating a plume that passes through the fishing area.

The composition of the bait must be heavy so that it does not immediately demolish. Often, clay or soil from the shore is added to the mixture. The base composition includes boiled millet, breadcrumbs, sunflower cake and a living component (wog, chopped worm, moth).

It is critical to add a live nozzle to the feeder. If you're catching a worm, you've got to have a chopped worm in your feed, and the bream finds food that moves and smells like wildlife faster than static porridge.

Techniques of catching and catching trophies

The way you do the fishing is, after you feed, the gear points go vertically down to the bottom, the line gets pulled, the fishing line gets fixed, the angler watches the nod, the bream pecking often looks like a steady but smooth climb, or a sharp nod down.

You don't need to cut in a sweeping motion like spinning, but with a short but steady jerk of the hand, and the amplitude of the cut is limited by the length of the arm, because the line is vertically stretched, and after the cut, the fish are pumped out, working as a rod, and choosing the slack with the coil.

Getting a big bream off a boat requires composure, don't drag the fish in jerks, rather tire it on a stretched line, when the bream comes to the surface, it can see the boat and rush to the side, be prepared to let it go again if you feel a strong jerk.

• 🐟 A slicker - Mandatory when fishing from the side, take bream with your hands slippery and dangerous (you can fall overboard).
• 🐟 lipgrip - a convenient tool for fixing the trophy, frees up hands to remove the hook.
• 🐟 yawner - necessary for the safe extraction of the hook from the mouth of a large bream.

If a fish comes under a boat, you don't have to bend over the side trying to reach it with your hands, and that's a risk of a boat flip, and you'd better get the fish in the bolt on the side, where the boat is more stable.

Seasonal Features and Safety

The best way to catch bream from a boat is in summer and early autumn, when the water warms up and the fish goes deep, but in heat, the clay can shift into the night or early morning, and safety requirements increase many times during this time of day.

Night fishing requires a bright flashlight, a white anchor light that can be seen from all sides, and life jackets on all crew members. The darkness is disorienting, and the risk of hooking or getting entangled in gear increases.

⚠️ Warning: Never get up in a boat while fishing for a large fish. Displacement of the center of gravity can lead to overturning, especially on narrow PVC boats.

In the fall, when the water cools, the bream gathers in huge flocks and goes to the wintering pits, catching at this time requires accurate hitting the "peak" where the fish is standing, and finding such places without sonar is almost impossible.

Remember the rules of GIMS: boat and motor documents, catch regulations and allowed sizes of fish. Let go of the change to enjoy the new trophy in a year. Take care of nature and enjoy the process!

Frequently Asked Questions (FAQ)