Effective hunting for a predator requires not only desire, but also the right tools. Egg fishing from a boat This is a specific technique that allows you to catch deep pits and steep brows that are not available for classical spinning, and this technique is especially relevant on large rivers with strong currents, where the pike and berch often have to look at the bottom.
The main feature of the method is to use the boat as an active participant in the process, the angler does not stand still, but slowly drifts or uses the anchor to fix at the desired point, lowering the angler. egg This approach allows you to apply the bait exactly to the parking area of the fish, which is critical for successful fishing.
Unlike sheer flare, there is a horizontal component of the wiring. Egg-laying It allows you to play bait over a wide range, mimicking the behavior of an injured fish, and it provokes the predator to attack even during periods of low activity when other methods are powerless.
Design and types of fishing cargo
The basis of the whole system is a bog, which fishermen affectionately call "egg," which is a lead or tungsten casting of an egg-shaped shape with a hole in the middle, through which the main line is passed, allowing the load to slide freely up and down without entangling the gear. Tungsten eggs are preferable to lead eggs, since with a smaller diameter they have more weight, which improves the sensitivity of the tackle.
There are several modifications to the cargo, and the choice depends on the fishing conditions: the classic egg has a smooth surface, but for very strong currents, faceted models or cones are better suited. Cargo cone It has better aerodynamics when falling and is more stable at the bottom, less carried by the flow of water. The weight of the cargo is selected individually, usually from 40 to 100 grams.
An important design element is a vertebral, which is often embedded inside the load or mounted on top, and prevents the fishing line from twisting during wiring. If you use homemade loaders, make sure that the edges of the hole are carefully treated so as not to damage the line. monophile Or a jerk cord.
Assembling tackle: fishing rod, coil and line
The rod must be tough enough to penetrate the pike's mouth from a depth of 10-15 meters, but have a sensitive tip to register cautious bites. The optimal test form is 40 to 100 grams, and the length is 1.8 to 2.1 meters.
It is better to use an inertial coil (Nevskaya or modern animators) or an inertial one of 3000-4000 size. Inertia coil It is preferred by many professionals, because it does not twist the line and allows you to immediately start etching the cord when you turn it down.
As the main line, a wicker cord with a diameter of 0.14-0.18 mm or a rigid monoleaf with a diameter of 0.35-0.45 mm is used. Kidney It gives you better tactile sensitivity, transmitting every touch with the bait of the bottom, and the monolesk cushioning the jerks of large fish and less noticeable in clear water, which can be a deciding factor.
Installation of equipment and selection of baits
The key is to assemble the work piece, and you put a locking knot or a bead on the main line, and then the egg load slides, and you tie a beef or a leash down the load, 0.5 to 1.5 meters away, and that's where the bait is mounted, and this is the spaced tooling that allows the squirrel or squirrel to play freely and naturally.
The most common baits are large mormy ("drawings", "Ural", "ants") or winter garments, and the perfect for a pike are narrow, elongated glitters with hooks equipped with Cambrian or wool threads. Mormy. It should be heavy so that it does not blow away from the hole (in this case, the points under the boat).
The color of the bait is chosen experimentally, but the classics are silver, gold and bright acid (lime, fire) colors. White and fluorescent options work well in murky water. It is important that the hooks are sharp and reliable, since it is difficult to break the bony mouth of a pike at depth.
Search tactics and boat anchoring
The success of fishing depends on 80 percent of the right location. Boat fishing is effective at depths of 6 meters or deeper. You need to look for sharp changes in depths, entrances to pits, dumps and beds. The predator is at the bottom, so the wiring must take place in the bottom layer.
Anchoring is critical. Unlike spinning throwing, here the boat needs to be placed across the current or at an angle to catch a particular area. Often two anchors are used ("stretching") for rigid fixation. However, in high winds or currents, it is more effective to catch drift, when the boat slowly blows with the wind, and anglers adjust the depth of release of cargo.
The active fish is searched by fan fishing, first the top eyebrow is checked, then the middle of the dump and the bottom, and if there is no bite for 10-15 minutes, the position should be changed. echoer In this type of fishing - an indispensable assistant, allowing you to see the relief and clusters of fish in real time.
Wiring technique and bait animation
Egg fishing is very different from spinning. There's no throwing. You lower the load to the bottom, you pick a slack, and you start playing. Basic wiring consists of lifting the load 30-50 cm from the bottom and abruptly lowering it, and when the load falls, the leash bait makes a fading oscillation, which is what the predator causes.
The amplitude and frequency of the flicks vary. At the beginning of the fishing, aggressive play with a large amplitude is recommended to attract attention from a long distance. If the fish is standing at a point but not pecking, switch to a small, trembling game at the bottom. Pauses At the bottom point is a mandatory element; often the attack occurs precisely at the moment of the bait.
It's important to keep track of the load's contact with the bottom. The line should be stretched, but not stretched. When fishing from a boat on the flow, the line often presses to the board, which creates sailing. You need to choose the angle of the rod so that the cord exits the water at right angles, minimizing the effect of water flow on the tackle.
The table below will help you to orient in the selection of cargo weight depending on the conditions:
| The force of the current | Depth (m) | Weight of the cargo (g) | Type of bottom |
|---|---|---|---|
| Weak. | 5-8 | 40-60 | Il, clay |
| Average | 8-12 | 60-80 | Sand, seashell |
| Strong. | 12-18 | 80-120 | Stone, pebbles |
| Very strong. | >18 | 120-150+ | Solid, rocky. |
Seasonal Features and Safety
Egg-catching is most effective during open water, when the predator rolls into deep wintering pits, late autumn and early spring, and in summer it also works, but requires more accurate search for active fish that may not be at the bottom, but in the ponds.
Safety on the water is priority number one, and fishing from a boat on the current, especially with heavy loads and anchors, carries risks. Anchor falla It should be easily accessible for rapid circumcision in case of a hook or a risk of rollover.
⚠️ Warning: Never wind an anchor rope on your arm or leg! A sharp snatch of a boat or a strong current can cause serious injury or drowning.
Clothing should be weather-friendly. It's always colder in the depths and winds than on the shore. Use waterproof suits and life jackets. Remember, fatigue from monotonous work with gear comes quickly, take breaks.
⚠️ Warning: When fishing in the dark, there must be running lights on the boat and a bagel on the head.
Frequently Asked Questions (FAQ)
Can I catch eggs from the shore?
Technically possible, but extremely inconvenient, it's vertically tailored and depth controlled from the boat, and it's more efficient to use bottom gear or spinning from the shore.
What diameter of the line is better for a leash?
For leash on the perch, use fluorocarbon with a diameter of 0.25-0.30 mm. It is less noticeable in water and resistant to abrasion against the shell, unlike wicker.
Why is the cargo stuck in the rocks?
This is a common problem. Try using cone or pear shaped cargoes with a smooth surface, and it also helps to install the loader higher on the main line so that the bait plays above the bottom debris.
Do you need a nod on the fishing rod?
When fishing in deep water with a wicker nod is often not necessary — the bite is passed to the hand, but for visual control and bait play a short hard nod from the lausan will be useful.