Summer heat often dictates its conditions, driving the predator to deep areas of the reservoir or forcing him to hide in shady snags, where standard wiring of the glitter or wobbler simply does not get, and it is at these moments that plumb fishing comes to the fore, allowing you to catch complex verticals and hold the bait in close proximity to the fish, this method requires the angler not only high-quality equipment, but also understanding the behavior of underwater inhabitants in thermocline.
The essence of the method is to vertically lower the bait from the board of the boat, which allows you to effectively control the angular horizon even in a strong current or wind. Vertical component It's a critical part of this, because predators often don't want to go up into the water forage, and the sounding sounder that's used in conjunction with the sheer flaming technique gives them a tremendous advantage over coastal spinners, whose baits just fly over the heads of passive fish.
Unlike the classic spinning, where throw range and wiring speed are important, the key factors are the sensitivity of the tackle and the ability to read the slightest changes in the bottom relief. You do not need to waste energy on constant throwing, which is especially important in a hot afternoon. anchor-false Over a perspective point and methodically explore each meter of depth.
Selection and preparation of boats for sheer fishing
The stability of the boat is critical for effective fishing in the plumb. Small inflatable mattresses or narrow canoes will be constantly blown by the wind or the current, which will knock out the game of bait and scare the cautious predator. The ideal choice will be PVC boats with hard transom and low-pressure inflatable floor (LDPT) or full-fledged aluminum. Cossacks The width of the hull allows you to sit comfortably on board with a partner and control two holes at the same time.
Special attention should be paid to the anchoring system. For a plumb fishing, it is not enough to simply throw an anchor to the bottom; you must be able to maneuver the boat's nose against the current or the wind to maintain the vertical. anchor-strain This is especially important when fishing at depths of more than 5 meters, where demolition even half a meter can remove the bait from the visibility of the fish.
The comfort of the fisherman also affects the result: prolonged exposure to a static pose requires a comfortable seat with the ability to adjust the height. If you plan to catch together, make sure that the cylinders or sides of the boat are high enough to protect the equipment from splashing, but do not interfere with the view into the water when calming. Stability of the platform This is the foundation without which a subtle game of easy bait is impossible.
⚠️ Warning: When fishing from a boat, it is strictly forbidden to get on board or make sudden movements, as this can lead to rolling and rolling over the boat, especially if you are alone.
Set of tackles: rods, coils and fishing lines
The rod for sheer flare is radically different from the spinning one. It does not require long range, but requires maximum sensitivity and rigidity. The optimal length of the rod is from 1.2 to 1.8 meters. Longer whips will interfere in the boat, and shorter ones (the longest ones will interfere in the boat).less than 1 metreThe rod test is matched to the weight of the bait, but usually does not exceed 20-30 grams.
The coil must be reliable and have a good friction. Many experienced anglers prefer to use it. multiplet Or the 2000-2500 Shimano class without the need for a straight line, because vertical fishing puts it in layers, and any bumps can cause the loops to fall off and the beard to form at the most inappropriate moment.
The main line is best used wicker cord diameter 0.10-0.14 mm. The rod has minimal stretching, which allows you to transmit to the tip of the rod the slightest touch of the fish to the bait. Monophile fishing line is only allowed in shallow water or when catching very shy fish, but it is very stretched at depth, hiding a bite. Visual control The cord also helps determine the nature of the bottom and the presence of hooks.
☑️ Checking tackle before exit
The nod is another important element of the arsenal, especially when fishing for light mortuaries or glitters. It can be made from a clockspring, laussan or metal plate. The nod's hardness is chosen experimentally: it should not bend under the weight of the bait in statics, but must clearly signal the touch of the fish. Some anglers successfully catch without a nod, relying solely on tactile sensations through the rod form.
Electronics: sonar as the main assistant of the fisherman
Modern plumb fishing is unthinkable without a sonar, and it's a tool that serves as an angler's eye, showing not only the topography of the bottom, but also the presence of fish, as well as the structure of the bottom. For steep fishing, scanning frequency is critical: the higher the frequency, the more detailed the picture. Standard two-beam sonarers may not be informative enough, so many people are switching to technology. CHIRP DownVision, which gives a photorealistic image of the underwater world.
When using a sonar, it's important to adjust the sensitivity and depth range correctly. If you're fishing at a depth of 10 meters, there's no point in keeping the range to 50 meters, that's going to reduce the detail. The optimal zoom is on the bottom layer where the predator is standing. thermoclin It is also often seen on screen as a horizontal band of noise; knowing its depth allows you to ignore the upper, oxygen-free layers of water where the fish do not bite.
| Echo sounder parameter | Recommended value for plumbing | Impact on fishing |
|---|---|---|
| Scanning frequency | 200 kHz and higher | Increases the detail of small objects |
| Scrolling speed | Maximum | It allows you to see the reaction of the fish in real time. |
| Sensitivity | 75-90% | It helps to distinguish between the structure of the bottom and fish. |
| Depth range | Auto or manual zoom | Increases the scale of the bottom layer |
Why does the sonar show arcs?
The fish on the sounder screen is often shown as an arc, and that's because the cone of the emitter is above the fish, and the signal goes to the edge of the cone (weak), then to the center (strong, closer), and back to the edge. If the boat is standing still and the fish is still, you'll see just a vertical line, and the arc comes when the boat or the fish moves relative to each other.
It's important to learn how to interpret data in real time. If you see a cluster of small fish (fish) on the screen, and over it or near large arcs (arcs), this is a sure sign of the presence of a predator. Precise positioning of the bait in this window often brings instant results. Without a sonar, fishing in the plumb turns into a lottery, especially in an unfamiliar pond.
Arsenal of baits: splashes, balancers and rattlelins
The choice of lures for sheer fishing is huge, but the leading ones are specific models designed specifically for vertical play. Balancers are classics of the genre. They have a horizontal body and tail tail tail, which causes the bait to make sweeping movements when the rod flaps. For summer fishing of perch and perch, the optimal sizes are from 5 to 9 cm. The color scheme is selected under the transparency of water: in murky water, they work. acid, in transparent - natural.
Vertical spherules (cloves, tubes, triangulars) work differently, they don't have active tail play, they just deviate from the vertical and plan downwards, and they have the advantage of being able to catch on the current and in deep pits where you need fast bottom delivery. Rattlins (vibes) are bladeless wobblers, which, when vertically wiring, create powerful vibrations that attract a predator from a long distance along the lateral line.
When fishing for rattlelin plumb pause 2-3 times longer than with spinning wiring. The predator takes time to approach the vibrating, but still bait.
And the classic winter sequins, especially for perch fishing, are also not to be forgotten: light, planing models with wool-coated tees or Cambrian-adorned treadmills work wonders for the passive predator. In summer, when fish are often moody, it is the light, slow-falling bait that can trigger an attack when the heavy balancer is ignored.
Wiring technique and search for active fish
The plumbing technique is based on cyclic tosses and pauses. The amplitude and sharpness of the stroke depends on the type of bait and the activity of the fish. The balancer is characterized by a sharp swing and a long pause during which the bait makes a reversal. The carnation flare is more often played with short, frequent twitches at the bottom. Rhythm of wiring This is a key success factor that the fisherman must select experimentally.
The fish start with a deep run, and if you go along a brow or a dump, you stop every 10 to 15 meters and check the bottom with a series of 10 to 15 strokes, and if the sounder shows fish but no bites, you should change the wiring horizon, lift the bait higher from the bottom, or experiment with color and size. Often, the predator is not at the bottom, but in the ponds, above the thermocline.
⚠️ Warning: When you bait the snag, don't make sharp jerks upwards, which can cause the gear to break or the snag to come to the surface. Try to ease the tension, let the bait plan below and gently stir it up.
The key to success is to keep your fishing horizon under control, and if you don't have a cool spot at the bottom, you can raise the bait by 1 to 2 meters, and the predator could move higher.
Seasonal Features and the Impact of Weather
Summer plumb fishing has its own nuances related to water temperature and oxygen regime. On hot July days, fish often go to deep pits where the water is colder and more oxygenated. However, deep deep pits can be frozen, so it is important to look for places with fresh water or current. vertical fishing It is the only way to get the fish, as it is standing in tight joints and does not want to move.
The effect of atmospheric pressure is also great. With a sharp drop in pressure, the sticks can completely disappear, and no tricks with baits will help. During such periods, it is better to shift the focus to finding active fish in shallow areas or in the mouths of flowing rivers, where the water is more saturated with oxygen. The wind and wave that interfere with spinning players are not so terrible for sheer fishing if the boat is reliably fixed, but they can knock down the game of light baits.
Night fishing in plumb is also a right to life, especially by perch. At dusk and at night, the predator goes to smaller areas, but the principle of vertical lowering of the bait remains effective, especially on the eyebrows. The use of light-storage elements on baits or chemical fireflies can significantly increase the number of bites realized.
Safety and ethics on the water
Boat Fishing is always risky, so safety is the number one priority. Having life jackets on everyone on the boat is a must, even if you are a great swimmer. Dramatic cooling in the water, cramping or hitting a log can happen at any time. Also, always carry a knife to cut a tangled cord, as a thin wicker can seriously injure your fingers if you snatch a strong jerk.
The environmental aspect is also not to be ignored: plumb fishing is often done in fish-rich areas, and it is tempting to catch all life, respect the catch rates set for your region, and release small fish to preserve the population. Leave behind a clean nature: all debris, including line trimmings and bait packs, must be collected and disposed of on shore.
Which fishing line is better to use for catching a pike in the plumb?
For catching a pike, a wicker line (cord) with a tearing load of 8-12 kg is optimal. It does not stretch, which allows you to feel a bite at a depth of 10-15 meters and make an effective cut of the hard jaw of the pike. The color of the cord can be any, but the bright line is more noticeable in the water for controlling the wiring.
Can you catch a boat without a motor?
Yes, it is. A rowboat is even more stable and silent, which is important for shy fish. However, the lack of a motor limits the range of the search and the ability to quickly return to a point in the wind.
Why does a fish see a bait but not bite?
There are several reasons: too active play, scaring off a predator; unnatural color of the bait; or fish saturated and does not want to attack. Try to reduce the amplitude of strokes, increase the pause or change the bait to a smaller and less noticeable one.