The compact 190 cm long craft occupy a unique niche in the inflatable vessel segment, providing the perfect balance between mobility and functionality. PVC boats 190 They are often the first major acquisition for beginner anglers and water lovers who are not yet ready to drive heavy models with powerful engines, and their main advantage lies in the ability to easily fit into the trunk of a car, which saves the owner from having to arrange a trailer or hire a special vehicle for transportation.
Unlike larger models, these sizes are lightweight, allowing them to be transported alone without assistance, but the cost of being compact is limited by the capacity and inability to install powerful powertrains. Inflatable boats 1.9 metres Ideal for quiet fishing on small water bodies, cruising in the coastal area or use as an auxiliary vessel on a yacht.
Modern manufacturing technologies allow us to create reliable structures that can withstand severe loads even at such dimensions. boat-building It has a direct impact on water behavior: flat-bottom versions are more stable on standing water, and keel models are better at handling excitement. Choosing a particular instance requires careful analysis of the specifications and understanding your personal needs.
Design features and materials
The basis of durability of any boat is the quality of the material used. PVC boats 190 Most commonly used five-layer reinforced polyvinyl chloride, which combines elasticity and high mechanical strength. the density of the fabric usually varies from 750 to 1100 g / sq. m, which provides protection against puncture on sharp stones or snags. PVC reinforced It does not rot, is resistant to the effects of petroleum products and ultraviolet radiation.
The key element of rigidity is an inflatable floor, which can be made using Low Pressure technology (LDPM) or be an inflatable flooring. Low-pressure bottom It creates a full-fledged keel, improving driving performance and allowing you to reach higher speeds, while models with inflatable tubes and rigid plywood or aluminum floorboard are easier to build, but require more time to prepare for launching.
โ ๏ธ Note: When operating inflatable floor boats (BBB) categorically cannot exceed the recommended pressure, since in the sun the air expands and can break the seams or the material itself.
The seams in high-quality products are made by welding with hot air, which creates a monolithic connection, stronger than the material itself. Seam tightness Cheap models are often assembled with glue, which over time leads to stratification and loss of sealing, especially at frequent temperature changes.
Welding technology
There are two main methods: two-seam (when the seams overlap) and three-seam welding. Three-seam welding is considered the benchmark of reliability, as it provides maximum joint area and eliminates the possibility of leakage even if the outer layer is damaged.
Capacity and passenger capacity
When choosing boats 190 cm The nominal carrying capacity of such models is usually 150 to 220 kg, including the weight of passengers, equipment, motor and boat itself. The actual payload is often less than the declared one, given the need for a buoyancy margin for safety.
The optimal operating mode for this size is considered to be on board one adult with a small amount of equipment. Two-seat boats 1.9 Formally, they can accommodate two, but the space will be extremely limited, and the landing height will decrease to a critical level, which is dangerous in choppy conditions.
- ๐ฃ Single fishing: Ideal for fishing with spinning or feeder from anchor.
- โ cruising: Comfortable for one adult and one child under 10 years.
- ๐ฃ Lifeboat: It is a great tender for a large yacht or boat.
It is important to consider the weight of the motor if it is planned to be installed. transom suspension These boats are often designed for motors weighing up to 10-12 kg. Exceeding this limit can lead to deformation of the transom or critical differentiation on the stern, which makes control impossible.
Compatibility with outboard motors
The question of motorization for PVC boats 190 It is particularly important because engine power directly affects speed and handling, and most manufacturers recommend 2 to 5 horsepower engines, and more powerful units are simply not needed because of the limitations of the body length and hydrodynamic drag.
Electric motors are becoming an increasingly popular choice for such dimensions. Electric motors It's quiet, lightweight and doesn't require complex maintenance, which is perfect for the lightweight inflatable boat concept. Gasoline two-strokes are also appropriate, but require a fuel mix and create more noise.
When choosing a 190 cm outboard motor, give preference to models with a short lower unit leg (S) so that the screw does not touch the bottom in shallow water and does not create excessive resistance.
transom on quality models is reinforced with overlays and has the correct angle of inclination. Other angle It should be adjusted by the position of the motor or the sling wheels to allow the boat to go to the sleeve. However, it is worth remembering that many boats with a length of 190 cm are structurally not designed for sleeve and operate in displacement mode.
| Motor type | Power (hp) | Weight (kg) | Recommended speed |
|---|---|---|---|
| Electrical. | 0.5 - 1.0 | 5 - 7 | up to 7 km/h |
| Gasoline 2T | 2.0 - 3.5 | 9 - 12 | 10 - 15 km/h |
| Petrol 4T | 2.5 - 5.0 | 13 - 18 | 12 - 18 km/h |
| Rowing | - | - | 3 - 5 km/h |
Packaging, transport and storage
One of the big trump cards boats 190 cm The folded boat can easily fit into a backpack or backpack bag, which rarely weighs more than 15-20 kg, and this allows the boat to be brought to the water even on foot, overcoming difficult stretches of shore where the car will not pass.
For storage in the off-season, the temperature regime must be observed. PVC It can lose elasticity at extremely low temperatures, so it is better to keep the boat in a warm room or garage. Before long-term storage (winter), the boat must be thoroughly washed, dried and treated with a protective compound.
โ๏ธ Preparing the boat for winter storage
When transporting in the trunk of the car, contact with sharp objects should be avoided. Protective tent Or a tight bag will protect the material from accidental punctures with keys or tools, and it is also not recommended to leave the packed boat in direct sunlight for a long time, as there can be a greenhouse effect inside the bag.
โ ๏ธ Warning: Never keep the boat fully pumped under pressure in a heated room in winter - temperature changes and air expansion can cause the seams to rupture.
Safety rules and care
Safety on the water begins with the proper preparation of the vessel. cylinder pressure Even ฮผฮนฮบ cuts can be fatal far from shore, so the repair kit should always be at hand.
Care for PVC boat It's about cleaning sand and dirt regularly, which act as an abrasive, using a soft sponge and special detergents to prolong the life of the material, and not using aggressive chemicals, solvents or gasoline to clean the surface.
- ๐ก๏ธ Sun protection: Use awnings or canopies for long periods of parking on the water.
- ๐จ Pressure control: Check the pressure every 2-3 hours, especially in the heat.
- ๐งผ Wash: After fishing, be sure to wash off mucus and fish oil with warm water.
An important aspect is the correct mooring. Anchor falla The boat must be fixed strictly in the center of the nose, so that the boat does not turn side to wave. 190 cm is enough anchor weighing 1.5-2 kg, as large sailing and low weight can lead to tipping in high winds.
Regular inspection of valves and seams is a guarantee of your safety; do not ignore even minimal etching of air.
FAQ: Frequently asked questions
Can I go out on a boat 190 cm to planing?
Theoretically, it's possible with a powerful motor (5 hp) and minimal load, but most models of this size are not designed to do so structurally, flat bottom and short length do not allow effective detachment from the water, and the risk of being hit by a wave is too great.
What is the life of a PVC boat 190 cm?
With careful operation and proper storage, quality PVC-reinforced boats They last from 7 to 10 years or more, depending on the frequency of use, storage and maintenance of the material.
Do I need to register a 190 cm boat in GIMS?
Under current Russian law, inflatable vessels less than 3 meters long and weighing less than 200 kg (including the weight of the engine, if any) are not subject to registration. 190 cm boats almost always fall into this category unless equipped with a heavy engine.
What is the difference between a 190 cm boat and 200 cm?
The difference of 10 cm may seem insignificant, but it affects the usable area of the cockpit and the carrying capacity. Boats 200 cm They often have full seats for two adults, while 190 cm is the borderline size for solo swimming.