Finding bream sites on vast reservoirs and large rivers is a challenge that is difficult to solve from the shore. The coastline is often overgrown, the bottom has a sharp difference in depth, and it can be hundreds of meters to promising eyebrows. bait-fishing It is considered one of the most effective and extractive methods that allow the angler to stand directly above the stern point.
But fishing from a boat imposes its own severe limitations on the choice of inventory, and you have to forget about the long feeder rods 3.9-4.2 meters long, since they are physically impossible to use comfortably in a confined space. fishing-rodShort feeders or nod gear adapted for vertical or sheer flare.
The success of the event depends not only on the right gear, but also on the ability to anchor, find a “table” or dump, and competently choose bait. In this article, we will discuss in detail what gear is necessary for comfortable fishing, how to equip them and what technical nuances need to be taken into account to trophy bream was in the cage.
Requirements for fishing gear from the board
The main difference between fishing from a boat and a shore fishing line is the angle of supply and the limited space for mach. If you are on a PVC boat or a metal "cossack", the length of the rod rarely exceeds 1.5-2 meters. rodwhich allow you to perform short but sharp cuts, necessary when using thin lines.
The second important aspect is sensitivity: At depths where bream is often standing, the current can be strong, and the nod or the top should clearly register the careful tick. Nod tackle It's not competitive because it allows you to feel every touch of the fish to the nozzle, and hard forms with a dough above 60 grams are rarely used, only on very strong currents.
And the weight of the tackle is also important, because it's not easy to hold a heavy rod in your hand for hours, so lightweight materials with a cork or EVA handle are preferred, and often anglers use special supports that are mounted on the sides, allowing them to free up their hands to work with bait or sonar.
⚠️ Note: When fishing from a boat, it is strictly forbidden to use long cages that can catch overboard or turn the boat over when a large fish is jerked. Use compact metal or mesh cages with a long rope that goes far into the water.
Flight fishing rods: design and equipment
Classical fishing-rod It's basically a short spinning or specialized form, 1.2 to 2.0 meters long, and these rods are often labeled "Boat" or "Cabo," and they tend to be fast or super-fast, which allows for instantaneous force transfer to the hook. This is critical for bream, because it has soft lips that are easy to tear when it's belatedly cut.
Equipment of such rods requires the use of a high-quality non-inertial coil of 2000-3000 according to the Shimano classification. On the spoole is wound monophilic fishing line with a diameter of 0.20-0.25 mm or wicker cord 0.10-0.12 mm. Tier is preferable at depths of over 6 meters, since it has no extensibility and better transmits a bite.
The grating signal often uses a side nod of a metal plate or a spring with a bright ball at the end, which allows you to catch in the dark using a headlamp, because the glow of the ball is clearly visible in the dark, and the mounting can be both deaf and sliding, depending on the activity of the fish.
For fishing on the current, use a feeder-net ("dump truck") on a separate cord, which will create a stable feeding plume that will attract bream to your gear, even if the current is strong.
Special attention should be paid to the choice of coils. The mechanism must be reliable, with a good friction, because a bream weighing 2-3 kg in the short can create serious resistance. Cheap models with a large backlash of the spools can lead to the formation of a “beard” when a sharp fish jerk.
Boat feeder: features of short rods
For those who are used to fishing, there is an alternative in the form of boat-feederThese are 1.8-2.4-meter rods with a test of up to 60-80 grams, and they allow you to throw the feeder not only vertically, but also to make short throws away from the boat, catching a large area of the bottom.
The key element here is the top (quivertype). For bream, the softest tops are chosen, painted white or yellow. They should bend under the weight of the feeder, but straighten at the slightest touch of the fish. Hard tops for flow in boat fishing are rarely used, since bream often takes the nozzle very delicately.
The boat feeder mounts are the same as the shore fishing, such as a paternoster, asymmetric loop or inline, but the length of the leashes is often increased to 1-1.5 meters to spread the nozzle and feeder further apart, especially if the bottom is silted.
☑️ Flight fishing rod
You can't do a wide swing like you would from the shore, so it's mostly a brush, and it requires a certain amount of skill and training before you go out on the water.
Nod gear for sheer glitter and mormy
The most sporty and gambling is considered to be fishing on the nod-rod This is often called wiring fishing or playing, and the rod is even shorter, 0.8 to 1.2 meters, often with extended-knob winter extensions or special on-board models.
The idea is to move the nozzle constantly down the bottom layer, and the bream, especially the big one, prefers the moving target, and the game can be smooth, with swaying, or sharp, with tosses, and the nod in this gear is not only a signaling device, but also a shock absorber that sets the rhythm of the game.
The liner is 0.14-0.18 mm in diameter, and the hooks must be sharp, with a wide undercoat, to reliably detect the fish with a short cut. Often the forearm hook or the body of a Mormouse is worn with Cambrian bright colors or beads, which provokes bream to attack.
⚠️ Attention: When fishing for a nod from a boat, there is a high risk of overboard fishing line or oars. Always keep the free end of the line under control and use yawners to extract hooks so as not to hurt yourself against the gill stamens of the bream.
The effectiveness of nod gear increases dramatically when you use a sonar, and when you see a fish on the screen, you can lower the Mormomile exactly to the bream parking level and provoke it to bite with the right game, which makes fishing a real underwater chess.
Comparison of equipment for different fishing conditions
The choice of a particular tackle depends on many factors: depth, strength of the current, size of the proposed trophy and personal preferences of the angler. Below is a comparative table that will help determine the choice of the main tool.
| Type of tackle | Length of rod | Best time. | Difficulty in mastering |
|---|---|---|---|
| The fishing rod | 1.5 - 2.0 m | Day, evening. | Low. |
| Boat feeder | 1.8 - 2.4 m | Anybody | Medium |
| Nod tackle | 0.8. 1.2 m | Day (active search) | High. |
| Donka with rubber | No rod. | Night. | Low. |
As you can see from the table, the rod is a versatile solution for the beginner. It's easy to operate and forgives many mistakes. Nod gear requires constant participation and high concentration, but gives the best result in the number of bites.
Night fishing often involves the use of bottom rigs without rods, where the tackle is simply put on board or special rods, in which case light alarms (“fireflies”) or sound “swinger” are used, but during the day this passive tactic works worse than active play.
The secret of night fishing
At night, the bream is out in shallower areas, closer to the shore or dumps, so at night it makes sense to move from a depth of 5-7 meters to a depth of 2-3 meters, where it is easier to find and catch.
Tactics of search and feeding from a boat
The main advantage of having a boat is mobility: you don't have to carry 10 kilograms of bait and a tent. You can quickly change places if the peck stops. But it requires smart tactics. First, with a sonar or depth measurement, you have a promising area: a brow, a pit, an exit channel.
Once you've chosen a point, you need to anchor properly, you need to be able to place the boat across the current or at an angle so that the gear doesn't get tangled, you need to have two anchors, a bow anchor and aft anchor, and that locks the boat at one point, which is critical to keeping the bait spot.
A critical factor in success is the creation of the right baking table. For bream, bait must be heavy so as not to be carried by the current, and fragrant. Often used mixtures with added clay or soil, throw bait strictly at one point, using a dump truck feeder or bucket.
If you're fishing on the current, you're going to put the bait upstream from the boat, so that the plume goes through the area where your hooks are, and the distance depends on the flow rate and the depth, which is usually 2 to 5 meters above the fishing point.
The key to success is to keep feeding. Don't wait for the peck to subside. Throw a portion of food every 10 to 15 minutes to keep the bream pack at the catching point.
Frequently Asked Questions (FAQ)
Which fishing line is better to choose for catching bream from a boat: a wicker or a monophile?
For depths of 4-5 meters and with nod gear, a monophilic fishing line is better suited. It stretches, cushioning fish jerks, and is less noticeable in the water. At depths of more than 6 meters and with strong currents, a wicker cord is preferable, since it does not stretch and allows you to feel the most timid bites, and also delivers the fish to the surface faster.
Can you catch a bream from a boat at night without a sonar?
At night, the bream often comes closer to the shore and becomes less careful, but the lack of a sonar makes it difficult to find the relief, so you should focus on visually noticeable changes in the coastline or use a marker load to measure the bottom before anchoring.
What size of hook is optimal for bream?
The optimal size of the hook according to the international classification is from No. 10 to No. 14. The hook must be of thin wire to easily enter the soft lips of the bream. Too large hooks can scare off fish, and too small can lead to frequent trophy gatherings.
Do I need to use a boat when fishing?
Using a boat lift is extremely difficult and even dangerous, as you can catch or flip. Breams weighing up to 1.5 kg are usually dragged into the boat, taking by the gill covers (gently) or grabbing your hand under the belly. For larger fish, use a special bagoric or kukan, lowering the fish into the water through the side.