Boat Fishing gives the fisherman access to areas of the water body that are physically impossible or extremely difficult to reach from the shore, and among the many ways of catching from the water, there is a high cost, which is often confused with trolling, but these are fundamentally different methods. Higher price This is an old, time-tested method, involving wiring the bait behind a moving boat, but without the use of complex gear and deep-sea devices.
The essence of the method lies in its simplicity: the angler rows with oars or uses a small stroke of the motor, dragging a line with a bait. Unlike trolling, which uses spinning reels and downrigters, here the tackle is often held in the hand or fixed on the sides, this allows you to feel each blow of the predator directly, without intermediaries in the form of a rod.
The effectiveness of this approach lies in the ability to quickly explore large areas, checking the presence of fish at different depths and types of bottom. Pike, perch and big perch They often react more aggressively to moving bait than to statically lying on the bottom, and understanding how to value from the boat correctly will allow you to significantly expand your catches and enjoy the dynamics of the process.
The essence of the method and the difference from trolling
Many newcomers mistakenly believe that the cost is just a primitive trolling, but the difference is fundamental: Trolling requires a spinning rod, a friction coil, and often a sonar to control the wiring horizon. Higher price It is based on the use of a simple fishing line, a motor or a short rod, and the control is carried out tactilely.
When moving higher, the boat moves at a low speed, often only by paddles, which allows it to catch complex areas: grassy sanks, snags and shallow waters, where the use of a powerful motor and heavy gear is impossible or ineffective, the predator in such places gets used to attacking fast-running prey, and the slow-floating bait becomes an easy victim for him.
The key advantage is that you can use the simplest tools, you don't need expensive voblers with a clear entrenchment, you just need to know how to tie the vermin or put the bait to make it work. Leska in this case, it acts as an extension of the fisherman's hand, transmitting the slightest changes in the behavior of the bait.
⚠️ Attention: When using a motor to drive, watch your speed. Too fast will cause the bait to fly to the surface or get entangled in the propeller, and the predator simply does not have time to keep up with it.
Equipment and equipment required
Preparing for high-priced fishing doesn't require buying specialized and expensive equipment. line It is usually a monophilic fishing line with a diameter of 0.4 to 0.6 mm or a wicker cord if more sensitivity is required, with a length of 20 to 50 meters, which allows for considerable distances to be captured.
The classics of the genre are fluctuating sequins, spinning sequins and tackles with dead fish or silicone. Live fishing uses a special float circle or simply a loader, which allows the bait to stay in the bottom layer. It is important that the bait has an active game even at the minimum speeds of the boat.
Fishers use a variety of tools to store and manage fishing lines, such as simple wooden or plastic rollers, inertial coils like the Nevskaya, or short side anglers, the main requirement for gear is reliability and the absence of unnecessary elements that can catch on the boat.
- 🎣 Leska diameter 0.4-0.6 mm or wicker cord of the corresponding bursting load.
- 🐟 Decoys: oscillators, turntables, silicone on jig heads, bait.
- 🧶 Motovilo Or a short rod for ease of control gear.
- ⚓ Anchor or cat anchor for fixing the boat when moving to another site.
Use a line of bright colors (salad, orange) - it is better seen in water, which helps to control the position of the bait and avoid hooks for the grass.
Choice of craft and preparation of boat
You can get a ride from almost any boat, whether it is inflatable. PVC The design of the vessel is very important, but the design of the vessel is very important, because PVC boats are good because they have soft sides, which are easy to attach gear, and they suppress noise, which is important when fishing carefully.
Metal boats are more resilient in the wind, but they require caution when working with the line, so as not to cut it against the side when jerking. When preparing the boat, you need to make space in the stern or on the nose so that nothing interferes with the free unwinding of the line. All unnecessary items that can create confusion, it is better to remove in the handnuts.
Particular attention should be paid to safety. Since the hands of the fisherman are often occupied with fishing lines or oars, the presence of a life jacket is a must, especially if the fishing takes place in windy weather or on the current. Sustainable When working with boats directly affects the effectiveness.
| Type of boat | Advantages for cost | Deficiencies | Recommended tackle |
|---|---|---|---|
| PVC (Inflatable) | Silent, safe fishing line | Less stability on a strong wave | Light rods, short fishing rods. |
| aluminum | High stability, durability | Noise, risk of line cut | Inertial coils, strong rods |
| Plastic. | Good hydrodynamics, comfort. | Weight, trailer requirement | Any tooling options |
It's important to consider the sailing of the boat. Inflatable boats with inflated bottoms and high cylinders are very sailing in the wind, which can make it difficult to control the speed of wiring, in such cases you have to work more actively with oars or use a fiber anchor for braking.
Fishing technique: rowing and movement
The main driving force in the classic road is paddles. The technique of rowing should be uniform, without sharp jerks, so that the bait goes smoothly, mimicking an injured fish or a tired insect. The speed of the boat usually does not exceed 2-3 km / h.
If you're using a motor, you have to set minimum speeds. boat-engine There's a trolling mode, but it can be too fast to travel, so you can use a gas-stop method or a fiber anchor that will slow the boat down and keep the speed up even on the engine.
The direction of travel is either against the wind or against the current, so that the boat runs smoothly and predictably. Cross-current, it is more difficult to control the tension of the line. The optimal trajectory is a shuttle movement along the edge or the grass border, where the probability of a predator being parked is maximum.
☑️ Preparation for the waterway
There's a nuance of working with multiple tackles at once, and experienced anglers often put two or three wheelers on the sides, catching different horizons, one can go along the bottom, one can go into the waters, which requires constant concentration and rapid reaction.
Tactics of searching for a predator on a pond
The success of the journey depends on the right location, and unlike shore fishing, you can check the deep dumps where the pike stands, or the "ends" in the thickets of the water lilies where the pike hides, and start by looking at the bottom relief.
If you zigzag or you go on parallel courses, you can quickly map a section of the pond, and if there's a biting in a particular area, you should linger and go more carefully, maybe changing the bait or the wiring horizon. Predator It is often localized.
It's important to pay attention to the color of the water and the transparency. In murky water, noisy baits and bright colors work better, in clear water, natural tones and quiet play. The time of day also dictates the tactics: in the morning and in the evening, the predator goes out into shallow water, in the afternoon goes to the depth.
⚠️ Warning: Never wind the line on your hand or finger when moving with a motor or in a deep place. A sharp jerk of a large catfish or pike can lead to serious injuries to the hand or even loss of a limb.
Secrets of the Night's Price
At night, the predator goes out into shallow water. Use glowing nozzles or petals with a phosphor. Movement should be even slower than during the day. Leska is better held in your hand to feel the slightest touch.
Typical Beginner Mistakes
The first and most common mistake is that you wiring too fast, and for beginners, the faster the boat goes, the bigger the catch area, but in fact, the predator just doesn't catch the bait, or attacks it with no enthusiasm, just by hooking it, and the speed should be such that you feel the bait play.
The second mistake is to use a line that's too thin to be invisible, and when you're moving, especially if you have grass or driftwood in the water, a line that's thin is a guaranteed cliff and loss of fish. strengthIt is not invisible, because the predator reacts to movement.
The third mistake is ignoring the weather, and in a severe storm or a very strong current, it's almost impossible to appreciate it: the boat carries, the line gets confused, the control of the gear is lost, and in such conditions it's better to wait out or go fishing in protected coves.
- 🌪️ Attempt to catch in a strong side wind, when the boat turns the side to the wave.
- 🎣 Using heavy loaders that drag along the bottom and collect all the grass.
- 🚫 Lack of yawn and extractor for quick extraction of hooks.
The main secret of success is constant contact with the tackle. The line must be stretched, but not pulled, allowing you to feel the game of bait and the moment of attack.
Safety and rules of conduct in the water
Boat Fishing is not only a pleasure, it is a responsibility. Compliance with the rules of GIMS is mandatory for everyone. Having life jackets on everyone in the boat is not a formality, it is a necessity. In the case of a rollover or falling overboard, a vest will save lives, especially if the angler is wearing heavy clothes and shoes.
You need to monitor the technical condition of the boat. Puncture of the PVC cylinder or crack in the hull of the metal boat can happen at any time. The rim should always be at hand. It is also important not to overload the boat, observing the passenger capacity standards.
Respect for nature and other anglers is an important aspect of culture: you shouldn't drive your motor close to other boats, creating a strong wave that can turn them over or confuse their tackle, and the noise of the motor also scares fish away from a long distance.
Keep in mind that there are restrictions on spawning times, and in many regions, the use of boats is strictly restricted or prohibited, and checking the current regulations in your area before leaving will prevent fines and confiscation of gear.
Can I get a PVC boat on the current?
Yes, but it requires some skill, and if you're on a strong current, the boat can carry faster than the bait moves, or if you're rowing against the current, the speed will be too slow, or if you're going to be able to move across the current, or if you're going to use a fiber anchor to adjust the rate of demolition.
Which line is better: wicker or monolesced?
For the sake of the price, monolesque is considered the classic option. It stretches, cushioning fish jerks, and is less noticeable in the water. The tiles give better sensitivity, but when caught on grass or snag due to lack of stretchability can lead to a break or breakage of gear. In addition, the wicker can cut hands when sampling.
Do you need a sonar to run?
Echo sounder is not a necessary attribute for the cost, as this method often involves catching visually visible places (grass border, bushes), but the presence of a sonar will help to find eyebrows and pits faster, which will significantly increase the efficiency of the search for predators.
How to deal with the flood of the line for the engine screw?
To avoid this, the line should be kept away from the diametrical plane of the screw. If you're sitting on the stern, it's more convenient to hold the line from the nose or from the side, passing it through the rod or just with your hand, controlling the angle. Using outriggers also solves this problem, but complicates the tackle.